SG16

5 ms·

1.
Enhancing Aesthetics in Connected Devices with Conformal Antennas(ygoliya.medium.com)
2 points by SG16 2y ago|0 comments
2.
by SG16 5y ago
The adhesive strength of inks to the substrate is measured with two tests: a tape test with 3M Scotch 234 and the conventional cross cut test. Usually, the change in electrical resistance is taken into account while performing these tests.
3.
Manufacturing next-generation electronics like they are T-Shirts(ygoliya.medium.com)
67 points by SG16 5y ago|22 comments
4.
by SG16 5y ago
Screen printing is a better choice for printing onto PCB surfaces. Copprint (an Israeli startup) has copper inks specificallý for FR4. Soldering is easier there... https://www.youtube.com/watch?v=1up5a7z6tjE Another option
5.
by SG16 5y ago
Yes you can do that.. a simpler way is to use screen printing directly on to a PCB
6.
by SG16 5y ago
Check this out, might be interesting for you: https://www.youtube.com/watch?v=OpObgG522sY
7.
by SG16 5y ago
Yes stencil or screen printing is much faster for mass production. It is faster and you could directly print on a variety of substrates like FR4, plastic, glass and even paper. I'll wirte about that next
8.
by SG16 5y ago
yes that's true, liquid inks usually have more resistance and this is a drawback. This is because the ink contains non-conducting materials which are required for the right viscosity and to prevent the silver to agglomerate. These can
9.
Rapid Prototyping with a $100 Inkjet Printer(ygoliya.medium.com)
146 points by SG16 5y ago|35 comments