4 ms·
How lucky was he to have a service manual that contained an actual plot of the PCB? That's got to be really, really rare.
by joezydeco 12y ago
How lucky was he to have a service manual that contained an actual plot of the PCB? That's got to be really, really rare.
- revelation 12y agoIt used to be really common.
- 13 12y agoIt's very common with older gear. I've bought some things in the past that came with a hand bound booklet with photocopies of the hand drawn circuit diagrams. It's still standard with obscure test equipment, but probably not for any sort of consumer product.
- userbinator 12y agoYou can still find service manuals and schematics for a lot of electronics (including laptops and phones) - just look on the Chinese side of the Internet. Ironically enough this availability is often through a lack of security rather than official release as most companies are against repair of their products.
- iaw 12y agoAny suggestions on what to search for for those of us that don't speak Mandarin/Cantonese?
- userbinator 12y ago"service manual" or "schematic" (with the quotes, to avoid any obnoxious query rewriting) and the name of the device works well, since they tend to use many of the English terms too.
- reedlaw 12y agoI would guess search on part numbers printed on the PCBs.
- dmicah 12y agoMany older consumer products had both schematics and PCB diagrams in their manuals, if not in the operation manual, then the service manual.
- joezydeco 12y agoI've seen lots of schematics in old consumer manuals, but not PCB layouts.
- stinos 12y agoIt's not really older consumer products, you can find brand new ones as well. It depends on the type of product (not the typical throw-away style) and the standards used by the company producing it. For instance gear like rotary hammers, hifi amplifiers, .. in mid to top ranges typically have ver, very complete service manuals. Including schematics.
- shabble 12y agoAn actual service manual intended for technicians who would be repairing the thing is likely to contain a lot more than the user manual would, although I have seen schematics/board prints in both. Even without that available, stripping it of all components and running both sides through a high-res flatbed scanner works surprisingly well, although top-bottom alignment can be a bit of a bugger afterwards. (And wouldn't solve his problem with the gaping hole in the middle) And it doesn't work on >2 layer boards, obviously. That said, the part he ended up with didn't look too complex, and it's possible it might have been inferrable from either a schematic or by reversing the rest of the board to a schematic and making logical assumptions about what must connect where. Things like appropriate track sizing for the high power traces might be a bit more guesswork though. It's a fairly common technique in board reverse engineering, although usually you have a couple of sacrificial units, so you don't have to worry about putting all the damn SMD components back on afterwards :P