3 ms·
Looking for a way to show an image over HDMI while my embedded system is booting, and then (seamlessly) switching over to the HDMI output of that system when bo
by amelius 2y ago
Looking for a way to show an image over HDMI while my embedded system is booting, and then (seamlessly) switching over to the HDMI output of that system when booting finishes. Any ideas how to accomplish that? In hardware, of course.
- actionfromafar 2y agoThere are a bunch of HDMI switches with buttons on them, and some with remotes. Doesn't seem too outlandish to rig these buttons or remotes to be controlled by the computer itself.
- myself248 2y agoSeems to me like the answer is to get the splashscreen going earlier in your boot process. If you know the display geometry, I suspect you can skip the DDC read and just hardcode the mode and stuff, which should save even more time.
- amelius 2y agoI asked for a hardware solution. On some embedded systems there is an entire hierarchy of proprietary crapware preventing access to the display controller, and I just don't want to look into it because chances are it is futile anyway and they might change it next year or I will move to a different platform and I'll have to reinvent this again, and again. Hence hardware.
- cpgxiii 2y agoIt really depends what embedded system (and display) you have. Most "reputable" embedded system/board vendors in the x86 space are going to offer a firmware customization tool, with one of the primary uses being so that you can brand the splash screen at startup. That gets you an image as soon as the firmware brings up the display controller, which should be very fast (i.e. well under a second). YMMV for less supported embedded systems, particularly those with more complicated/proprietary display bringup. Depending on the display in question (assuming you can control the display in use), you may have the ability to configure a splash screen in the display controller itself (the display controller vendor can certainly do this, whether or not they expose it to you is the question). The most complicated (but also most flexible) option is to get whatever the simplest FPGA that can support a HDMI TX and a HDMI RX for the display resolution you desire. Then you build whatever splash screen you want into the FPGA firmware, and whatever boot-finished detection you want to handle the switch from internal splash image to HDMI RX. You'll get the splash screen essentially as soon as your FPGA and HDMI TX power on. If you really know what you're doing, you could even get HDCP passthrough from the embedded system to the display to work here, although you probably can ignore that.