4 ms·
And by "the board" I trust you mean the MSI PRO X670-P WIFI motherboard. There's nothing incorrect about the behavior of the SSD when it's being operated outsi
by LeifCarrotson 2y ago
And by "the board" I trust you mean the MSI PRO X670-P WIFI motherboard.
There's nothing incorrect about the behavior of the SSD when it's being operated outside the prescribed voltage and power thresholds.
If there's a trickle (and to be clear, the 5V at 300 mA available from an HDMI cable is a trickle for a full motherboard) of current into the 3V3 bus on the ATX connector, something will be the very lowest PMIC to turn on. It's just that on this system, the SSD was the first thing. If anything, the SSD will probably be highly tolerant of brownouts because its LDO will run at around 1.9V.
- hulitu 2y ago> There's nothing incorrect about the behavior of the SSD when it's being operated outside the prescribed voltage and power thresholds. It shall set itself in Reset state.
- LeifCarrotson 2y agoThat would be nice, in practice, the SSD requires its power rails to start up in a particular sequence and with very particular voltages.
- shadowpho 2y agoOnly few devices are actually able to do that. Vast majority require require proper voltage sequencing, because to do otherwise is to add cost to your IC
- Dylan16807 2y ago> There's nothing incorrect about the behavior of the SSD when it's being operated outside the prescribed voltage and power thresholds. I'd put some more emphasis on "when", though. If it never comes back when power comes back that's not particularly correct.
- crest 2y agoThat's because if this theory is correct from the point of view of the SSD there was no reboot yet, because there was never any total power loss.
- Dylan16807 2y agoIt handles warm reboots without power loss just fine, so it deciding now it needs to wait for power loss seems like a flaw.
- wtallis 2y agoIf the SSD reacts to the start of a brown-out with supply voltage dropping way below spec as a signal that an unplanned power loss is happening, then it may do an emergency flush and shutdown that leaves it simply waiting for power to finish dropping to zero. It makes at least some sense for the drive to not try to wake up from that state without a clean power cycle.
- Dylan16807 2y agoI think "makes at least some sense" and "not particularly correct" can be true at the same time.
- smileybarry 2y agoIt should still handle PCIe probing and (logical) reconnection without a reboot, though, e.g.: PCIe redirection for a VM.