2 ms·
Okay, and I'm paraphrasing Louis CK here, you go make one if it's so sucky and imperfect. Seriously, how hard can it be? Get together a BOM for the $5 in part
by joezydeco 14y ago
Okay, and I'm paraphrasing Louis CK here, you go make one if it's so sucky and imperfect.
Seriously, how hard can it be? Get together a BOM for the $5 in parts, send it through DigiKey and have it in a couple of days. That's like what, an hour of time?
Then layout a PCB in your favorite schematic capture and send it off to a board house, quantity one. Two hours, tops. Never mind you're wasting 75% of the minimum PCB size.
While DigiKey and PCB Express are cooking, time to write some firmware. If you chose a nice chip like a Cypress part and have some experience, you could be done in another 2 hours. You do have a development kit on-hand, right?
Then take all the parts, solder them up in your reflow, burn the code, test, and assemble. Another hour? Sure. (Hope those boards were right the first time and didn't come in upside-down) Whoops, don't forget the drivers. Let's do a quick linux one.
So $20 in parts and board, and six to eight hours of your time. What's your time worth? $2 an hour? Cool, you're golden.
I tend to charge a bit more for my time, so it puts me in the range where $30 is a great deal. But then again, I'm using the old ScrollLock LED trick as my message indicator. It's free.
- astrodust 14y agoThe same group is making a very similar product, minus housing, for a $15 unit cost. Clearly there's some serious slack in this Kickstarter price.
- joezydeco 14y agoProbably not as much as you think. Remember that Kickstarter takes 5% and Amazon Payments takes 2%. Then the group has to pay federal taxes on that, which could be another 20%. Now we're close to $20 remaining for the device. Oh yeah, and I didn't even get into the costs of tooling and shooting a plastic housing. That's something a little more time-consuming and pricey than firing off an order to DigiKey and PCBExp on your credit card.