4 ms·
Is there any way to select between two HDMI signals? I have an nVidia Jetson but its boot sequence turns off the HDMI output at some point. It would be nice if
by amelius 2y ago
Is there any way to select between two HDMI signals?
I have an nVidia Jetson but its boot sequence turns off the HDMI output at some point. It would be nice if I could show a placeholder screen while the Jetson is booting. Would something like that be possible by using this RP2350 board?
- ale42 2y agoNot directly because it can't handle retransmitting the existing HDMI signal. You probably need to add a HDMI/DVI switch IC like this one: https://www.analog.com/en/products/ad8196.html https://www.analog.com/en/products/ad8196.html
- psd1 2y agoI've tried a few commercial hdmi switches, to share a monitor between machines. The switch time is long and the monitor doesn't reliably wake up. Perhaps it's related to eDID? Do you know how that chip is for real-world usability?
- kees99 2y ago> switch time is long and the monitor doesn't reliably wake up In my personal experience, obtuse monitor's firmware is often to blame. Using a switch with one extra input port, where all data pins are connected to ground (via series resistors), and switching to that port for a brief moment, before switching again to the real intended input, usually helps some.
- amelius 2y agoIsn't it possible to create a valid and stable HDMI signal based on two inputs? I can imagine that some memory is required to synchronize both signals. Is there an IC that can do that?
- dezgeg 2y agoI'd be surprised if that was not fixable in the Jetson with pure software changes.
- amelius 2y agoPerhaps but I don't have time to familiarize myself with their boot architecture. Also it might be different in their next version.