3 ms·
I bet there was something physically wrong with the cat5 wiring as the actual reason it couldn't do gigabit.
by Dylan16807 3y ago
I bet there was something physically wrong with the cat5 wiring as the actual reason it couldn't do gigabit.
- icedchai 3y agoIt probably only has 4 wires hooked up. That's all you need for 100 meg. Despite claims to the contrary, gigabit will work over cat 5 (just not 5e!) in the majority of cases.
- Libcat99 3y agoRegular cat5 is only rated at 100mbit. 5e will handle gigabit, and I've seen 5 work for short runs too.
- Dylan16807 3y ago5e will not just handle gigabit, it's enough to run 2.5gig at spec to 100 meters. 5 has the same bandwidth as 5e but allows more crosstalk. And gigabit is intended to work on cat5. If gigabit is not working on cat5 cables <50m, I put my money on there being something wrong with the hardware/install in that house.
- dboreham 3y agoGigE works totally fine on bog standard 25 year old Cat5 over 100s of ft.
- toast0 3y agoThe spec for older ethernet standards is with 100 meters of cabling with most of it un dense conduit. You can get away with lesser cable when runs are shorter and not in dense conduit. I had a run of mixed cat5e and cat3 that did gigE just fine. I'm not sure I've ever seen actual cat5 in the wild, but from what I've heard, most cat5 will test to cat5e spec too. I have 10g-base-t running reliably on cat5e as well. (30ish meters)
- riehwvfbk 3y agoWas going to post the same thing. I had a new construction townhouse in the Bay Area that had Ethernet. The max speed was either 10 or 100 Mbps depending on which jack was used. Opened up the jacks to discover that the cables were stripped of the jacket for at least 6 inches, the twisted pairs were untwisted and this mess was jammed into the wall behind the jack. At every single location. The worst offender wouldn't connect at all. That had a foot of jacket stripped off. Re-crimping all the jacks made everything work at 1 gigabit. In summary, general tradespeople don't know how to install Ethernet.
- justsomehnguy 3y agoMy best anecdote on that is when an Ethernet wallplug was punched down with a flat screwdriver... which worked as hardware firewall for the SMB traffic. Everything else worked fine: ICMP, HTTP/S... but not SMB. After I re-punched it with a proner Krone it started work fine for the SMB traffic just fine.
- antisthenes 3y agoYep, I had a cable that was working at gigabit, until it was pinched by a door and bent really hard. Then it started working at 100 MBPS.