3 ms·
I can look at it. I'm a hobbyist like you but I have been using KiCad and making PCBs for a few years now. If you want to be anal you can print the PCB from Ki
by JKCalhoun 3y ago
I can look at it. I'm a hobbyist like you but I have been using KiCad and making PCBs for a few years now.
If you want to be anal you can print the PCB from KiCad on a regular laser printer at actual size and "stuff" your paper PCB with the components you intend to install. I've used a push-pin to poke small holes in the paper PCB and then threaded the resistors, etc. into the holes to get a sort of sanity check that the components are going to actually fit with one another.
The latest KiCad has a 3D viewing mode that seems to have a similar benefit. But I had a few components on my latest PCB that KiCad didn't know about so there was no 3D model for those components. (I could probably hunt for these component's 3D models on the web but I am too lazy.)
Otherwise, I see lots of "can you review my PCB?" on r/PrintedCircuitBoard/ (https://old.reddit.com/r/PrintedCircuitBoard/ https://old.reddit.com/r/PrintedCircuitBoard/).
Here's another YouTube video I've sat through: https://youtu.be/3FGNw28xBr0?si=57iSLz2EFxOdUmXn https://youtu.be/3FGNw28xBr0?si=57iSLz2EFxOdUmXn
I'm interested in the course as well though. I suspect there is a lot I could learn.
- willis936 3y agoLaziness is the enemy. I spend a lot of time on things that some might consider frivolous. I always make sure to set up pin assignments and constraints properly so ERC and DRC checks mean something. I've found that the 3D models are quite helpful in finding pain points in clearance for multi-board assemblies, large components, and user interactive components. It's also really handy for checking mounting configuration (hole size, standoff height, will standoffs obliterate traces, etc.)
- dekhn 3y agoI did spend the time to find 3d models on the web to plug into my 3d views and it was definitely helpful. Rather than paper, I think you could Kicad-design a 2D grid of holes matching an existing proto board (https://www.amazon.com/ElectroCookie-Solderable-Breadboard-Electronics-Gold-Plated/dp/B07ZYNWJ1S https://www.amazon.com/ElectroCookie-Solderable-Breadboard-E...) and then do the placement and routing in Kicad, and then finally assemble the board in place. To avoid fritzing.