4 ms·
TL;DR - because the wire attachment point is usually to the rear of the center of gravity.
by Animats 3y ago
TL;DR - because the wire attachment point is usually to the rear of the center of gravity.
- 36841007 3y agowhen a succinct John Nagle TL;DR is worth a handful of animated diagrams.
- kadoban 3y agoThe graphs and diagrams are more useful because they show what variables the tilt depends on, ie how to reduce the tilt if you want to.
- Groxx 3y agoAnd it's hard to fix without poking something through the wall that you probably want to keep pristine, because glass weighs a lot. Unless you modify the frame. Or screw into the top of the frame. Or loads of options that aren't taken for one reason or another because "the frame has a wire across it" is utterly dominant.
- progbits 3y agoSlight forward tilt can be desired, eg. to help with dust accumulation.
- Gordonjcp 3y agoAnd just you wait until the author of the article tries to work out why the wire isn't straight across but has a bend in it when the painting is hanging on a hook. The tension on cable strung between two points is a function of the weight pulling down on it, and the reciprocal of the sine of the angle the cable makes where the weight hooks on. For it to be straight, the latter becomes infinite...
- ChuckMcM 3y agoYes, however the discussion is more valuable than that. I once bought a framed poster at a garage sale and discovered when I got it home that it had a steel plate across the bottom of the frame. I thought it a bit of over engineering for adding frame support (it attached to the back of the frame with machine screws) but when you hung the poster it hung flat against the wall. I took me a couple of weeks to figure out the person do did that was moving the CG of the framed print closer to the wall which made hit hang nearly flat on the wall. When reading the referenced article I realized it also allowed for an arbitrarily tightly stretched cross wire because the steel plate would bear all of the stress, not the art. That was something I had not thought of!
- planede 3y ago> I took me a couple of weeks to figure out the person do did that was moving the CG of the framed print closer to the wall which made hit hang nearly flat on the wall. As it was at the bottom of the frame, it also moved the CG lower, which also helps to reduce the tilt, even if the CG remains a little bit to the front. > When reading the referenced article I realized it also allowed for an arbitrarily tightly stretched cross wire because the steel plate would bear all of the stress, not the art. I don't really get this, if the plate was at the bottom. I assume the stretched wire would be attached somewhere at the top half, so the rest of the frame would need to bear at least some of the stress.
- ChuckMcM 3y agoIt was a plate, probably 3" "tall" and as wide as the frame, attached in four places at each of the corners. As a result it held the frame rigid (much like a corner bracket would). If you pulled the top toward each other, in addition to the top bar of the frame resisting that pull, the bracket would resist and attempt to make the bottom/side angle less than 90 degrees.
- rob74 3y agoMy naive answer to this problem would be "well, then don't use a wire to hang them, use something that forces the frame against the wall". Which leaves you with the issue that the frame might pull the nail out of the wall - but that also seems to be a solved problem: you can either use special picture hanging hooks which have up to 3 nails, with the nails angled upward so they won't be pulled out by a force facing downward. Or you can overengineer it and use a wall plug. This might not solve the author's problem, who seems to swap the pictures around often, but I assume most people don't do that...