3 ms·
I do not know if by "build" you mean building from scratch a real PDP-11, or just repairing an old real PDP-11, or just building an accurate emulator. Most rea
by adrian_b 4y ago
I do not know if by "build" you mean building from scratch a real PDP-11, or just repairing an old real PDP-11, or just building an accurate emulator.
Most real PDP-11 from the later years of the seventies had processors made with bipolar bit-slice circuits from the AMD 2900 series and memories made with 16 kbit chips like Mostek 4116 and these had to be supported by a large number of MSI and SSI Schottky TTL integrated circuits.
Maybe a few such ancient integrated circuits in working state could still be found, but for a complete PDP-11 a very large number is needed (a 256 kB memory needs 128 DRAM chips, the maximum 4 MB memory needs 2048 DRAM chips, the CPU might need 40 to 100 bipolar logic chips). I do not believe that attempting to reproduce the large size and the great power consumption of a real PDP-11 can provide an improved self-teaching experience in comparison with the implementation of a clock-cycle-accurate emulator of PDP-11/70 on a modern FPGA board.
- dboreham 4y agoAlso should say that I am a digital design engineer from the 70's/80's so tackling this tech is not a problem per se, but the goal is more about time-travel -- re-creating the smell, sound, flashing front panel lights, heat and feeling of being in the room next to a multi-user pdp-11.
- dboreham 4y agoI have a complete set of cards pulled 20 years ago from a working system.
- kabdib 4y agoI knew a guy (Marc Crispin) who had a PDP-20 in his spare bedroom. His power bill was . . . large.
- dboreham 4y agoYeah an 11/70 needs 3-phase which I don't have.
- adrian_b 4y agoIt is more important if you have enough electrical power available. Building or buying a 3-phase inverter or a power supply unit that could replace the original power supply are much easier tasks than building the logic boards of PDP-11/70, which you have. If the power requirements exceed what is available at your location, you could still make the PDP-11/70 work for very short times, by using a large enough UPS with a 3-phase inverter or with a substitute power supply, and charging the UPS, then starting the PDP-11/70 with the UPS disconnected from mains. The power requirements can be reduced a lot in comparison with a real PDP-11/70 if only the processor boards are used and the memory boards are replaced by a modern FPGA board implementing the protocol of the DEC memory bus. The maximum size of the PDP-11 memory (4 MB) is small enough that it can be implemented with the internal SRAM of many FPGA chips, no external DRAM memory is needed.
- dboreham 4y ago> It is more important if you have enough electrical power available. I have 7.5KV in my yard so absolute power is not a problem. Good point about emulating memory and thereby getting away with a smaller PSU. Also need to emulate a disk drive. I have controllers for various drives but no physical drives (those are tricky to get working today even if they can be tracked down due to degradation of materials).
- msla 4y agoWhere a "PDP-20" is a later version of a PDP-10, marketed as a DECSYSTEM-20 and intended by DEC to run TOPS-20.
- dekhn 4y agooh. that was the first DEC I used- remember it from my childhood. It was replaced shortly after with a VAX/VMS machine. I fled to UNIX shortly after.