5 ms·
Has anyone tested a 'submersible phone' (whatever water-proofing level that may be... and wireless charging whilst submerged?
by samstave 4y ago
Has anyone tested a 'submersible phone' (whatever water-proofing level that may be... and wireless charging whilst submerged?
- deleted 4y ago[deleted]
- 867-5309 4y agoLinus Tech Tips challenge accepted
- samstave 4y agoA good litmus may be: get a phone to a certain level of depletion of batt Get (2) phones' batts to same level. Place each on a charged, but one submerged, one not. Time to 100% ==?? Measure this multiple times/multiple device types Build a table of "underwater charging rating of xFactor..."
- hulitu 4y ago"Place each on a charged, but one submerged, one not" Unless the connector is waterproof ( i doubt it) , don't try this at home. Water is a good conductor.
- spicybright 4y agoAnd make sure to plug it into your bathroom outlet for the fault protection!
- SketchySeaBeast 4y agoWhich only makes sense because how else would you test this beside sitting in the bath with a stopwatch?
- samstave 4y agoTry sitting in tub with a toaster?
- robocat 4y agoDC plus water equals electrocorrosion[1] if the pins are in contact with water. USB 5 Volts is easily enough to corrode most electronics - certainly made a huge mess of one phone I owned that got dunked while charging. [1] electrocorrosion isn’t used much as a word, but it should be. Google electrolytic corrosion, direct current corrosion, stray current corrosion. [null] https://knowledge.electrochem.org/encycl/art-c06-cathodic.htm https://knowledge.electrochem.org/encycl/art-c06-cathodic.ht...
- CuriousCosmic 4y ago> electrocorrosion Isn't that just galvanic corrosion?
- robocat 4y agoGalvanic is two dissimilar metals, usually with an electrolyte like wet soil or water. One metal will corrode far faster than the other e.g. zinc sacrificial anode will corrode to protect iron. Corrosion due to electric currents is different. A few Volts in reverse and you could make iron the anode to corrode and protect a zinc cathode (Cathode and Anode depend on current direction, e.g. they swap when charging a battery). Two parts made of the same metal can be can be corroded with an electrolyte between them, with low AC or DC voltage driving differences.
- Dylan16807 4y agoConnector? This is about wireless charging. If you're worried about the wire to the charger itself, I'm sure they've thought of that if the charger is submersible. (Do any of those exist? I'm only finding a splash-resistant one.) And if the charger isn't submersible it'll be outside the bucket and the cable will be fine. I do see some wireless charging waterproof battery banks. No cable needed for that.
- andrew_ 4y agoMy S10e has been in the Gulf of Mexico, several feet down for a few minutes at a time, more times than I can count. I boat and fish extensively, and the phone hitches a ride in my pocket pretty frequently. Two years later, it's still going strong.
- Razengan 4y agoObviously not quite a phone but would the Apple Watch count? Says the Series 7 can go down to 50 meters. https://support.apple.com/en-us/HT205000 https://support.apple.com/en-us/HT205000 Oh but you can’t use the touchscreen in water.
- samstave 4y agoWetWare is Harder than Software.