4 ms·
Fusion 360 handles this perfectly. In fact it has thread creation directly built in (both textured and modelled explicitly). I recently needed to make a nut f
by dekhn 5y ago
Fusion 360 handles this perfectly. In fact it has thread creation directly built in (both textured and modelled explicitly). I recently needed to make a nut for a specific thread, and did it by subtracting the thread from a volume. If you're careful you can inspect the results and see how to offset the thread slightly to move from a too-tight fit to a simple press fit.
- Animats 5y agoFusion 360 is the same CSG engine as Inventor. It just has fewer features and is tied to "the cloud". Inventor has pro features such as "would you like a finite element analysis of the weak points in that", and "Warning - gear tooth counts are not relatively prime and may result in uneven wear".
- deleted 5y ago[deleted]
- Tossrock 5y agoFusion360 has FEA in the Simulation workspace.