2 ms·
Challenging, but almost always possible. Most flash chips have a write-enable line that you can put a switch on. Usually have to cut a trace but often can avoi
by Scoundreller 5y ago
Challenging, but almost always possible.
Most flash chips have a write-enable line that you can put a switch on. Usually have to cut a trace but often can avoid soldering right to the legs by following traces.
Was a common thing to do to receivers (“Integrated Receiver Decoders”) back in the paytv days. Thankfully they had firmware on a parallel eeprom and config stuff on a smaller serial eeprom (that could handle 1m writes instead of 1k writes). Receivers could have a lot of wires especially after they implemented some lock-detection that had to be countered with some 74ac logic that could disrupt the 2nd step of starting a write job.
Should be doable for something like a router or cable modem, but maybe not on something like these WD drives. Like a mod chip without having to worry about the vendor trying to counter you.
Of course you’re still screwed if something is only non-persistent but at least any issues are resolved with a simple reboot.