3 ms·
a lot of electronics tutorials start with resistors and capacitors and have you build RC circuits and measure their decay, but I found that a diode-first class
by dekhn 5y ago
a lot of electronics tutorials start with resistors and capacitors and have you build RC circuits and measure their decay, but I found that a diode-first class makes a lot more sense.
Once I discovered constant current controllers, I started to have real fun with LEDs. Sure, you can use a resistor to drop voltage but that's just spewing heat. Switched Constant current controllers are much more elegant not very hot at all and have excellent control over intensity.
These days I typically run LEDs at half their rated current; they are still plenty bright and run FAR cooler than max current.
- exmadscientist 5y ago> not very hot at all Any linear driver will have equal efficiency to any other, and PWM just changes the overall on-time, not the efficiency during that time. So a simple resistor, if you can live with its variability in the application, can be used just as effectively as a fancy trimmed current source. They're even relatively similar in difficulty to PWM a single output, though current sources will usually win for multiple equal outputs. > I typically run LEDs at half their rated current Half? I start at 500uA these days, or 1/10th to 1/40th of "rating", and have been known to go down as low as 50uA, with a series resistance of 100k! Modern LEDs, especially the 0402 white ones, are amazing.
- dekhn 5y agoI'm sorry, I should have pointed out that I work with LEDs that are about 1000-1000000 stronger than you, so power dissipation from a linear regulator is significant. For example here's what I work with: https://www.amazon.com/MARSWALLED-Daylight-DC36V-38V-Spotlight-Searchlight/dp/B07CG1SBR3 https://www.amazon.com/MARSWALLED-Daylight-DC36V-38V-Spotlig... and https://www.amazon.com/MEAN-WELL-HLG-150H-36A-Single-Switching/dp/B00FRBMXM0/ https://www.amazon.com/MEAN-WELL-HLG-150H-36A-Single-Switchi...