7 ms·
BL602/BL604 RISC-V WiFi and Bluetooth 5.0 SoC will sell at ESP8266 price point
- noodlesUK 6y agoIt will be great to have another cheap microcontroller in the space with much more advanced radios. Is there any info on power draw? I didn’t see that from the initial specs.
- FullyFunctional 6y agoIt's right there on the page but it looks like he blocks copy and paste which is ridiculous: 0.5 uA (deep sleep), Wifi Rx: 18 mA. The first link (https://www.cnx-software.com/2020/10/12/hi3861-based-hispark-wifi-iot-development-board-supports-liteos-and-harmonyos/ https://www.cnx-software.com/2020/10/12/hi3861-based-hispark...) has more information. I'm puzzled about his Rust remark; if it's an RV32 then Rust already supports nostd on riscv32i-unknown-none-elf, riscv32imac-unknown-none-elf, and riscv32imc-unknown-none-elf.
- deleted 6y ago[deleted]
- zokier 6y agoIf those figures are right, that would put this new chip as dramatically better than esp32, right?
- ohazi 6y agoYes, the esp8266 and esp32 are power hogs and run quite warm, which is why you don't see them in battery powered gadgets very often. It'll be interesting to do real world measurements when this chip is available.
- dragonelite 6y agoI think i saw the rust thread on twitter. It was about Ferrous system supporting this board with their course and cli tools.
- JJJollyjim 6y agoProbably also with a peripheral access crate (type-safe register definitions) and and HAL integration.
- jamesmunns 6y agoSo, there's language support for it, but it'll still be necessary to have driver support, ideally a whole support library in Rust. Most BLE or WiFi enabled microcontrollers have a binary blob for driving connectivity, or deeply C based code that can be a challenge to integrate idiomatically in Rust.
- taneliv 6y agoI don't speak Chinese, but this linked page seems to have some information on the power draw: https://www.ednchina.com/news/2020SONGSHANHU-3.html https://www.ednchina.com/news/2020SONGSHANHU-3.html . I don't know if that is just the WiFi component, or the whole SoC. You can also see two other kind of SoCs they contrast their BL602 offering against.
- systemvoltage 6y agoWe've seen ESP8266 and ESP32 succeed tremendously in the maker space. We've yet to see widespread adoption in commercial and professional applications - that's coming, but I am surprised why IP for bluetooth/wifi is so expensive outside of Chinese chip makers? ST, NXP, Microchip, Renesas, etc. have really expensive SoCs - $15/chip and over. These giants seem to be sleeping. What's preventing them from competing with the Chinese? Also, we have horrendous price gouging for memory. A mere 128k to 256k bump in memory spec on a microcontroller will send you back a $1.20 in chip price. Is there some CCP-gov subsidy going on to capture the market? Espressif's ESP32 is such an extraordinary chip with 500kb+ memory and yet, it is an order of magnitude cheaper than anything close from western suppliers. What gives?
- xondono 6y agoThe trick is that ESP* chips implement a lot of the stack in firmware. This saves a lot of IP in dedicated hardware that allows for price reduction, but has it’s drawbacks, mostly in terms of energy consumption. There’s also a good amount of problems involved in having a non-auditable (non certified) piece of firmware running in a coprocessor that handles communications, and being closed source and Chinese doesn’t help. The difference is generally that the maker space doesn’t need to be production ready. By the way, Murata has modules on the ~6$ range (depending on what features you want)
- baybal2 6y agoNot only the radio is software, cores themselves, as I understand, are not hard macro, and I find it more surprising that such very generic synthesized chip is not an even bigger power hog.
- monocasa 6y agoJust throwing the entire design at the synthesizer these days seems to be pretty close to a collection of hand laid out hard macros. The synthesizer being a lot more aggressive about optimizing out signals that leave the macro (and downstream uses of those signals, so those global optimizations that are hard for a human to see) seems to make up for it's deficiencies with perfect local layout.
- childintime 6y agoFinally a promising RISC-V ESP32/ESP8266 alternative. My question now is if the ADC is any good. Not so on the ESP's.
- ducktective 6y ago12-bit ADC vs ESP8266's 10-bit (and similar to ESP32's 12-bit). Interesting thing is that BL602 has a 10-bit DAC!
- MrBuddyCasino 6y agoNo ESP32 contender, half the RAM and no I2S peripherals means audio applications are out. Too bad.
- monocasa 6y agoHalf the RAM might be OK given that it seems to follow the 'execute out of a flash cache' rather than 'loading the image fully into RAM' strategy the ESP chips use. I could def be misunderstanding it though. And I2S being gone is very unfortunate, but I like chips with upstreamed LLVM backends enough that a really cheap CPLD as a SPI/I2S bridge wouldn't be the worst thing in the world for my designs I use for at home projects.
- ducktective 6y agoIt supports XIP QSPI Flash (https://en.wikipedia.org/wiki/Execute_in_place https://en.wikipedia.org/wiki/Execute_in_place). I wonder, wouldn't the loading of instructions be limited by QSPI speeds? (Much less than CPU clock speed)
- monocasa 6y agoThere's nearly always a cache sitting between the flash controller and the CPU when an XIP flash scheme is used, normally integrated in the flash controller itself.
- eisa01 6y agoWhy do chips like these not have 5 GHz Wifi? Living in a city, the 2.4 GHz band is crowded, and a lot of devices require you to play with your router settings to set them up [1] e.g., some Mill heaters must be set up on a 2.4 GHz network using a channel below 10 [2] [1] https://millheat.zendesk.com/hc/en-us/articles/213305665-My-heater-does-not-connect-to-the-Millheat-app-What-do-I-do- https://millheat.zendesk.com/hc/en-us/articles/213305665-My-... [2] https://millheat.zendesk.com/hc/en-us/articles/213310805-WiFi-router-settings-when-using-Mill-WiFi-heaters https://millheat.zendesk.com/hc/en-us/articles/213310805-WiF...
- fhars 6y agoBecause everything else is on the 2.4GHz band and so adding 2.4GHz Wifi doesn't require any new HF circuitry.
- JJJollyjim 6y agoThat wouldn't apply to Espressif since they started with WiFi, right?
- baybal2 6y agoYou can make 2.4ghz radio on more or less the same process as the logic. With 5ghz, silicon cmos is still possible, but the power consumption will be very bad. The need for a specialty RF process is a big limiter.
- baybal2 6y agoWhat I mean is that you will have to go for 2 pieces of silicon, (one for radio on a specialty process, and another for regular CMOS logic) instead of one. Even desktop wifi chips are still made in 2.4ghz only variants to save some cost in the lowest end, and for the chip priced in cents, it is completely not an option at the moment.
- punnerud 6y agoA lot of the problem is often not the band is crowded, but that often one too many send out DeAuth packages. This is fixed in WPA3.
- deleted 6y ago[deleted]
- punnerud 6y agoBL602 ordered from AliExpress (BL604 is not available). Looking forward to long range connection between BL602 and RPi 4.0 (that also use Bluetooth 5.0)
- digitelxp 6y agoIt appears that the Raspberry Pi 4 does not support Coded PHY for extended range or any optional Bluetooth 5 features. Many Bluetooth 5 chips out now do not support those optional features, so you need to confirm the physical layers available to see if a device is suitable for your project.
- spuz 6y agoHow do you expect to program it? Have you found any English documentation anywhere?
- fulafel 6y agoWhat kind of tooling / libraries are used with these? Eg IP or 6Lowpan stack.
- Lurkars 6y agoThe biggest problem of ESP32 is power consumption on BLE fein my point of view. Would really like to see a competitor where ble runs with an ULP or so.
- throwaway4good 6y agoIs it illegal to import the HiSilicon Hi3861 (which seems to be a more powerful chip) into the US? I can see modules with that chip are just a few dollars on alibaba: https://www.alibaba.com/product-detail/Hi3861-Wifi-Chip-Hikvision-CCTV-Camera_1600074487980.html https://www.alibaba.com/product-detail/Hi3861-Wifi-Chip-Hikv...
- coretx 6y agoCan we abuse this as a SDR ?
- pantalaimon 6y agoWhy not use a chip intended for that? https://www.microchip.com/wwwproducts/en/AT86RF215IQ https://www.microchip.com/wwwproducts/en/AT86RF215IQ It's less than 4€ and you can build and SDR with it https://tinysdr.org/ https://tinysdr.org/ https://github.com/uw-x/tinysdr https://github.com/uw-x/tinysdr
- Avamander 6y agoThe Bluetooth and WiFi stacks look proprietary, that's unfortunate. Anyone knows if there's any documentation or source out there about interfacing with the WiFi/BT peripheral?