3 ms·
> I chose to overcome this by heating the VCC pin with my soldering iron and very carefully lifting it off the pad. This is a convenient, but rather crude solut
by Scoundreller 6y ago
> I chose to overcome this by heating the VCC pin with my soldering iron and very carefully lifting it off the pad. This is a convenient, but rather crude solution which may result in snapped off leads so use at your own risk!
If that mishap on an SOIC chip occurs, don’t fret, you can usually shave off a bit of the plastic and get enough pin surface to solder a jumper to VCC.
An alternate method is to follow the VCC trace and cut it, then solder your own wire to the unlifted lead and a nearby capacitor with a switch. Beware that you might power more than the chip if the trace continues, but that’s usually fine. Sometimes this is a good thing because you still power pull-up resistors.
Yet another option is to place a glob of solder across 4 pins, heat them all up, and lift half the chip. The other 4 legs will be hot and soft enough to bend easily.
Finally for the non-VCC connections, could follow the traces and find easier places to solder to rather than a bunch of side-by-side leads.
- Jenda_ 6y ago> Finally for the non-VCC connections, could follow the traces and find easier places to solder to rather than a bunch of side-by-side leads. There is actually an unpopulated footprint for a bigger package around the 8-pin flash, which can conveniently be used for this.
- Scoundreller 6y agoExtra points if you can find a via that kynar can fit into, a test point, or something exposed with lots of masking around. Use a dab of hot glue to keep your wire in position: http://www.yavuzg.com/images/6in1jamma/IMG_2570_zpsf0b4kind.jpg http://www.yavuzg.com/images/6in1jamma/IMG_2570_zpsf0b4kind....