4 ms·
You’re supposed to drag-solder those. Look it up on YouTube, it’s super easy. The hardest part is positioning the chip, but it’s actually easier than with an ov
by Ecco 6y ago
You’re supposed to drag-solder those. Look it up on YouTube, it’s super easy. The hardest part is positioning the chip, but it’s actually easier than with an oven, because you can rework it if you only solder one or two pins :)
- na85 6y agoWow, just looked up a video and some guy did an 0.5mm pitch chip pretty darn quickly. Thank you!
- Ecco 6y agoYou’re welcome! Also, flux. Lots of it. Buy some good one, and use tons of it. Then clean the hell out of your PCB!
- IshKebab 6y agoThere's an even easier way than drag soldering - just solder it normally, without worrying about bridges. You can put tons of solder on it. The use some desoldering braid to soak up the excess solder. It will remove all the bridges and leave perfect joints.