3 ms·
On one chip a trace will have a jog that's two 90-degree turns. On the other chip, the same trace will have 45 degree bends. If the 45 degree one is the newer
by userbinator 6y ago
On one chip a trace will have a jog that's two 90-degree turns. On the other chip, the same trace will have 45 degree bends.
If the 45 degree one is the newer version, that might be a DFM optimisation - there is common folklore around PCB design that 90 or acute angles can cause various problems, with some hint of truth to it, but I suspect there are similar constraints in photolithography. If the sharp corner was causing yield losses, a newer revision would definitely address that.
- dboreham 6y agoElectrons fly off as they try to take the 90 bend.
- amelius 6y agoElectrons in a typical circuit have a drift velocity that is very low (order of millimeters per hour). Of course, the electrons individually are very fast, but they are also almost as fast when there is no voltage applied.
- userbinator 6y agoThere is a bit of truth to that --- sharp corners are more prone to electromigration: https://en.wikipedia.org/wiki/Electromigration#Via_arrangements_and_corner_bends https://en.wikipedia.org/wiki/Electromigration#Via_arrangeme...
- kens 6y agoBoth chips have a mixture of 45 and 90 degree bends, so it's nothing that obvious. About 98% of the paths are the same and then there are these changes with no discernible pattern.
- egsmi 6y agoIn the suspected auto layout sections does it follow a modern standard cell convention?
- kens 6y agoIt's about as far as you can get from standard cell. Every logic gate is different with the transistors shaped to fit in their surroundings.
- egsmi 6y agoThat’s crazy. It seems like it would make the software so much harder but I guess it would get the density up. I wonder how they closed timing.