5 ms·
Except spinning rust is staring at the prospect of flash storage eating their lunch. Flash isn't THAT far away. If these increased areal density techs don't pa
by AtlasBarfed 6y ago
Except spinning rust is staring at the prospect of flash storage eating their lunch. Flash isn't THAT far away.
If these increased areal density techs don't pan out, they are done.
- zozbot234 6y agoFlash storage is not nearly as reliable as spinning rust, given comparable density. The spinning rust niche is pretty much unassailable, and now SMR lets the industry expand into tape-like use cases. What WD did was a huge screwup for the reasons OP talks about, and they had to backpedal quickly.
- bcrl 6y agoI disagree. Flash storage used within the range of its capabilities is more reliable than spinning rust. Failure of flash is quite predictable and can be managed through the use of over provisioning and advanced error correction codes. Flash failures tend to be localized and directly related to wear caused by writes. This can be managed by properly written firmware. In contrast, traditional HDDs are mechanical devices. Total failure of a hard drive tends to happen unpredictably. A poorly time impact can result in damage that is fatal for the entire device. Once debris starts bouncing around inside of an HDD, damage can be catastrophic. I will agree that early flash drives were not as reliable as they should have been, a problem is that mostly solved in SSDs produced today. Software issues in SSDs were a problem in the early days -- I even had an early Intel 32GB SLC SSD that bricked itself even though it was nowhere near the end of its rated life. It takes time for firmware developers to develop an understanding of the problem space and create a sufficiently advanced test bed to exercise some of the more complicated corner cases associated with wear related issues near the end of life. SSDs today are a very different beast than those on the market 10 years ago. Lately I've been getting some exposure to the archival problem space. Event today, tapes are still an important part of the storage hierachy, especially when it comes to legal compliance by certain large businesses.
- zozbot234 6y agoYou can choose SLC (or limited MLC) and overprovisioning to make flash storage quite reliable, and perhaps even preferable to disk in some respects. But that comes with severe compromises in density and you're still vulnerable to bugs in the opaque, proprietary Flash Translation Layer, which has no equivalent in (non-SMR) hard disks.
- toast0 6y ago> Software issues in SSDs were a problem in the early days -- I even had an early Intel 32GB SLC SSD that bricked itself even though it was nowhere near the end of its rated life. They're still a problem. HP had two separate instances of branded SSDs fail when the lifetime counter rolled over (I guess they didn't test everything the first time). My experience with running around 10k SSDs and spinning drives in a datacenter was that spinning drives would fail more often, but would provide clear warning signs if you check SMART stats regularly, providing opportunity to replace failing drives without losing redundancy if your storage systems are flexible. SSDs would fail significantly less often, but there would rarely be a warning --- disks would just disappear, never to be seen again. Our use was relatively low writes, we weren't anywhere near the lifetime write counts. Some SSDs would really tank performance if they declared bad sectors, while they were moving things around, host driven I/O was very slow. I don't remember which brand that was.
- bcrl 6y agoIf I were buying SSDs, HP is not at the top of my list of well known SSD vendors that have an excellent data integrity record, probably owing to an experience many years ago with HP branded MegaRAIDs that only had a known data corruptor in the HP "blessed" firmware. My personal theory is that consumer gear tends to get better tested over the long run since millions of units out in the field will result in a lot of weird corner cases actually happening. The electrical engineers I know love it when their products are in high volume production, as it makes it a lot easier to find patterns and the underlying causes of failures. In contrast, low volume niche products will always have lurking bugs deep in obscure corners that haven't been exercised.
- rasz 6y ago
- tssva 6y agoUnless they have changed their response in the last couple of weeks WD hasn't done any backpedaling. They instead just clarified which drives use SMR and then issued a statement trying to gaslight buyers of their NAS drives that this issue occured because they purchased the wrong type of drive for their use case. You know purchasing a drive marketed as a NAS drive in a NAS.