3 ms·
Depends on the optics. "1 mW" isn't enough information. Focus that down enough and it could burn, but so too can sunlight. It also depends on the time of day
by sandworm101 6y ago
Depends on the optics. "1 mW" isn't enough information. Focus that down enough and it could burn, but so too can sunlight. It also depends on the time of day. In the dark of night your iris will be open, making a laser much more dangerous. Sunlight is more powerful but as a general rule your iris isn't going to be open during sunlight. A billion years of evolution have made our eyes rather good at handling sunlight. We have no natural defense againse lasers, especially invisible IR lasers. (Stay away from the cheap green lasers from china. They often pump out huge amounts of IR.)
FYI, the general legal limit for "pointers" is 5mW.
- amelius 6y agoDid you read the section on laser safety? https://www.repairfaq.org/sam/lasersaf.htm#saftoc https://www.repairfaq.org/sam/lasersaf.htm#saftoc EDIT: I read it again and the crux of the matter seems to be this: > The ability of the retina to dissipate heat is not dependent on the area covered, but the periphery (circumference) of the exposed area! The blood vessels are in the retina and not the sclera (the surface under the retina) - it is the blood flow that dissipates the heat and so can only act on the edge not the middle of the exposed area. In circumference terms, the ratio drops to 7 times. Furthermore because the larger spot is less efficient at dissipating heat, the effective power delivered by the laser beam is only about 2 times greater than that of the spot formed by the sun.
- sandworm101 6y agoYa. The cited math is very short, missing many environmental variables. Lasers safety are also a small part of my job (military). I've got a pile of "pointers" that would blind in an instant, several in the watt-class (ie >1000mw). Anyone can buy 50,000mW laser "pointers" for a couple hundred bucks. I had everyone at work bring in their kid's laser "pointers" a few months ago. Almost every one of them tested above 5mW. 10-20mW was the norm. Assume that everything on ebay/amazon is above 5mW. I refuse to stay in the same room as a working laser engraver/cutter. They are generally in the 2000-4000mW class, enough for even a slight reflection to instantly create a colour-specific blindspot.
- tonyarkles 6y ago> They are generally in the 2000-4000mW class, enough for even a slight reflection to instantly create a colour-specific blindspot. And many of them are IR, so you wouldn't see the leaky beam at all until it zapped your eye.
- TheSpiceIsLife 6y agoYep, the one I work with is 4kW 1070nm. A typical human eye will respond to wavelengths from about 380 to 740 nanometers.
- TheSpiceIsLife 6y agoDo you mean 2000 - 4000 watt, rather than milliwatt? The one I work with is 4000 watt, capable of cutting up to 20mm carbon steel, 20mm stainless, and 12mm aluminium. It’s fully enclosed with dual electromechanical locks on each door, and an air extraction system with dust and collector.
- sandworm101 6y agoThat one isnt handheld. It isnt part of a 200$ machine being sold to highschools. Danger is always both technical and situational. I did mean mW. A mW-class laser is more than enough to do instant damage, damage that would put an end to a person's career as a pilot.
- deleted 6y ago[deleted]