3 ms·
The classic goodput vs throughput debate. E.g. Gigabit Ethernet is most commonly actually physically transmitted at 1.25 gigabit/s because of 8b10b coding. Ethe
by zamadatix 7y ago
The classic goodput vs throughput debate. E.g. Gigabit Ethernet is most commonly actually physically transmitted at 1.25 gigabit/s because of 8b10b coding. Ethernet requires interpacket gaps, and the packetization itself changes overhead. Then of course you have other protocol overheads underneath you could consider, and how much overhead the data you were transmitting has due to encoding of it itself.
In the end there is really "bandwidth" which is how much symbol "space" is available and various levels of "goodput" which is the rate of whatever you're calling useful data.
- rzzzt 7y agobaud vs. bps
- zamadatix 7y agoOther things like unusable symbols (e.g. IFG added to above) make it more nuanced than that.
- Dylan16807 7y ago> Gigabit Ethernet is most commonly actually physically transmitted at 1.25 gigabit/s because of 8b10b coding. Fiber often uses 8b/10b. Over copper it's much more complicated. USB 3.0 is an example of simple 8b/10b. 4Gbps data, sent at 5Gbps. Ethernet over twisted pair, well... 10mbit Ethernet turns each bit into either a 01 or a 10 and sends those on the line. 100mbit Ethernet applies 4b5 encoding to get a 125MHz signal, then it uses this to drive an encoding called MLT-3. In MLT-3, the final output cycles through -1, 0, +1, 0 over and over, and each bit decides whether it advances or doesn't advance. Gigabit Ethernet does a complicated encoding to turn batches of 8 bits into 4 separate voltages from -2 to +2 (so 5 levels). It then sends these simultaneously over all four wire pairs at a grand total of 125MHz.