4 ms·
For those not familiar with reading papers, just read the conclusion and see figure 12 on the same page. It's a fair summary of both the obtained results, requi
by lucb1e 8y ago
For those not familiar with reading papers, just read the conclusion and see figure 12 on the same page. It's a fair summary of both the obtained results, required hardware and possible mitigation.
They mention "sub-$1000 hardware" as required, but for 1GHz and 40MHz, a HackRF One knock-off of $150-$200 should do just fine. Heck, you might be able to run with some DVB-T sticks at $20 depending on the chip in your particular model and production batch (the one for $15 I had went from 20-800MHz, just short of a gigahertz).
- vectorEQ 8y agothis magnetic probe they use, you think it's hall probe -> frequency analyser? perhaps a hall sensor + arduino would work ? (sorry im not good with electronics :D..?) i'm wondering how to get the magnetic signal into my hackrf or arduino. how to catch it? they just mention using a probe, and i see on the picture some device which looks just to be hooked up to antenna cable?
- vvanders 8y agoCould just be a coil of wire with a LNA in front of it. Would be curious about the details as well.
- DoctorOetker 8y agoI wonder if one could use the read head from an old HDD
- garaetjjte 8y ago1GHz is easily in range of RTLSDR, but required 40MHz bandwidth is problematic. LimeSDR for 300$ could be suitable.
- vvanders 8y agoYeah, that's pretty darn impressive to do that with a magnetic probe, no physical connection needed. Gone are the days of putting a sense resistor between the safe and battery, just pick it out of the air now.