13 ms·
When I read the tittle I thought if you have to do a lot of soldering you're not doing design for test very well. (I do a lot of soldering) I'm also really ag
by Gibbon1 9y ago
When I read the tittle I thought if you have to do a lot of soldering you're not doing design for test very well.
(I do a lot of soldering)
I'm also really against the recommendation to use lead solder. First off it's expensive and harder and harder to get. But in a professional setting it opens you to a regulatory mess.
That said 60/40 lead solder is trash compared to 60/37/3 lead tin/antimony solder.
- joezydeco 9y agoAgreed. Even a small amount of lead cross-contamination can cause your product to get rejected in RoHS regions. This has happened to my company. Getting a palette of product shipped back to you is not a fun event.
- jessaustin 9y ago60/37/3 lead/tin/antimony solder A quick search seems to indicate that this is not available for purchase anywhere?
- Gibbon1 9y agoI think I have the ratio's wrong, I think it's 0.5% antimony. But I haven't seen it in about 20 years. Even before then most solder was 60/40.
- pravda 9y agoThat's because the OP is clueless. :-( DON'T use lead-free solder, unless forced to. Lead-free solder is a nightmare. Use leaded 63/37 solder, although 60/40 is fine.
- Doxin 9y agoLead free solder definitely isn't a nightmare. The early versions might've been, but modern lead-free is just fine. The only gripe I have with it is that the flux is more aggressive and eats into my soldering iron tips a lot faster.