5 ms·
Article says: Obviously this 8 – 10GHz clock range would be based on Intel’s 0.07-micron process that is forecasted to debut in 2005. These processors will run
by wmf 10y ago
Article says: Obviously this 8 – 10GHz clock range would be based on Intel’s 0.07-micron process that is forecasted to debut in 2005. These processors will run at less than 1 volt, 0.85v being the current estimate.
Intel introduced a 65 nm (0.065 micron) process in 2006. The "Cedar Mill" Pentium 4 processor ran at 3.6 GHz at a whopping 1.3V although a small double-pumped part of the processor ran at 7.2 GHz. It could be overclocked to 4.5/9.0 GHz at 1.4V.
The discrepancy between 0.85V and 1.3V was caused by the end of Dennard scaling. Basically transistors require much more voltage than predicted and thus consume far more power than predicted. Although the transistors can technically run at 9 GHz, the resulting power density is very difficult to cool.
- yuhong 10y agoThe fun thing is that they were reducing the power with each stepping by that time.
- kristianp 10y agoIt appears that the double-pumped adds aren't used any more. I thought they would have been good to keep, Adds being so common.
- Tuna-Fish 10y agoThey are not used because with transistors that keep getting smaller but that don't get much faster, it's better to just have more add units in parallel than it is to run the ones you have faster. A modern Intel CPU effectively has 4 add units to the 2 of the P4.
- ZeljkoS 10y agoYes, more about the end of Dennard scaling: https://en.wikipedia.org/wiki/Dennard_scaling#Breakdown_of_Dennard_scaling_around_2006 https://en.wikipedia.org/wiki/Dennard_scaling#Breakdown_of_D...
- amelius 10y ago> Although the transistors can technically run at 9 GHz, the resulting power density is very difficult to cool. But nowadays we have processors with multiple cores, where sometimes you need only 1 core (and it needs to be fast). So would it be an idea to increase clock frequency for those cores, but multiplex them quickly to allow them to cool?
- lmm 10y agoThere's a limited form of this already - on many multicore processors if you're running a single-threaded workload then "turbo boost" or similar will allow the one running core to clock higher than normal. Not aware of the multiplexing idea being implemented, but I'm not sure how much value that would give - I suspect the overall amount of heat to be dissipated is the limiting factor more than where exactly it is in the package.
- jzwinck 10y agoThat's just a bit different to Intel Turbo Boost which has been widely deployed for a while. When fewer cores are needed it will increase clock speed on a small number of cores if there is work to do. Some BIOSes have settings to completely disable a bunch of cores to enable more turbo boosting. This isn't as sophisticated in thermal as what you outlined, but it saves on cache coherence.
- mschaef 10y agoOther people have covered Intel's TurboBoost feature, but this reminds me of something GM did with the Cadillac Northstar V8 back in the early 90's. https://en.wikipedia.org/wiki/Northstar_engine_series https://en.wikipedia.org/wiki/Northstar_engine_series When the engine did NOT have coolant, it would run only one bank of cylinders at a time and alternate between the two to let them cool. The system was at least somewhat effective. There's a story from the time about a journalist that was testing the feature in the desert. He stopped at a truck stop after conducting the test and amazed the folks at the stop by opening the hood, filling the engine with coolant, and driving off like nothing was amiss.
- rasz_pl 10y agohttps://en.wikipedia.org/wiki/Intel_Dynamic_Acceleration https://en.wikipedia.org/wiki/Intel_Dynamic_Acceleration introduced in ~2007 in Core 2 mobile CPUs (Penryns I think). You can load Middleton modded bios into your oldshool Thinkpad R61/T61 and it will enable dual IDA[1] in top CPUs. http://forum.notebookreview.com/threads/t61-x61-sata-ii-1-5-gb-s-cap-willing-to-pay-for-a-solution.459591/page-8 http://forum.notebookreview.com/threads/t61-x61-sata-ii-1-5-... You can even load modded(by chinese) modded middleton bios, solder one wire and plop $8 T9550 CPU for 2.66GHz boosting to 2.8GHz. You could even use quads, but its beyond uneconomical with cpus being more than whole used thinkpad T420. http://forum.thinkpads.com/viewtopic.php?f=29&t=110620 http://forum.thinkpads.com/viewtopic.php?f=29&t=110620 This was Intels first steps and not a lot of OEMs enabled IDA. Turbo Boost was next, introduced in Nahalems. https://en.wikipedia.org/wiki/Intel_Turbo_Boost https://en.wikipedia.org/wiki/Intel_Turbo_Boost [1] dual IDA is a trick forcing IDA on both cores. Throttlestop utility is also able to turn it on.