3 ms·
Not the OP, but a guess: A lot of RAID cards will switch from writeback mode to writethrough when the battery is low, because they can't guarantee that the (bat
by duskwuff 10y ago
Not the OP, but a guess: A lot of RAID cards will switch from writeback mode to writethrough when the battery is low, because they can't guarantee that the (battery-backed) cache will persist across a power failure. Writethrough mode makes writes significantly slower, which could cause problems higher up the stack.
- bogomipz 10y agoYep they will also go write through during a battery "learn cycle". The DELL PERC controllers are notorious for this. And there is poor visibility into this. You basically have to know about the awful MegaCli utility to gain any insight. What is the learn cycle? "The purpose of the learn cycle is to determine the condition of the battery. The learn cycle charges, fully discharges, and then recharges the battery in order to determine the condition and health of the battery. The battery full charge capacity degrades over time and a battery is deemed completely degraded when it can no longer hold a charge for 24 hours and must be replaced." Source: https://discuss.pivotal.io/hc/en-us/articles/204955498-FAQ-Greenplum-DCA-PERC-Battery https://discuss.pivotal.io/hc/en-us/articles/204955498-FAQ-G...
- Dylan16807 10y agoWhat kind of trash-tier reliability-increasing hardware stops working for a day every 90 days? I'm really surprised they didn't put two or three batteries into it.
- true_tuna 10y agoAll of them. You learn to disable learn cycle, most people learn that the hard way. I switched to flash backed cache for this reason (along with being sick of replacing batteries)
- true_tuna 10y agoThis is correct. I managed a large database fleet and can confirm the performance degradation.