4 ms·
A train having less than 256 axles in Switzerland doesn't exactly sound limiting, ridiculously long trains are coal and ore lines (e.g. BHP Billiton) or huge ge
by masklinn 10y ago
A train having less than 256 axles in Switzerland doesn't exactly sound limiting, ridiculously long trains are coal and ore lines (e.g. BHP Billiton) or huge general freight in large countries (Canada, US). Switzerland is a fairly small country with steep gradients, a 256 axles limit would give a limit of ~60 cars.
- kozak 10y agoThey don't say that this is an upper limit. The number should not _equal_ 256 (or 512, etc), but it can be larger or smaller than that.
- masklinn 10y ago> They don't say that this is an upper limit. It's not, but considering the context going above would mean going through the limit which would be dangerous, during exit the counter would mark a railroad section as unoccupied before underflowing back to occupied. It might also have interesting failure modes during entry.
- tveita 10y agoIt sounds like that would momentarily register the track as free between the 256th and the 257th axle, a nice little race condition.
- shawabawa3 10y agoIt's not that it has to have less than 256 axles, it has to not have exactly 256 axles (or presumably multiples of 256)
- masklinn 10y agoConsidering the context is track vacancy detection, I'd think even going through the counter would be dangerous (as it could temporarily mark a rail section as unoccupied during its occupation before underflowing, a good old race condition) and would thus be operationally avoided as a recipe for disasters.
- jcranmer 10y agoIt wouldn't be difficult to require that a count of 0 be maintained for several seconds before registering as vacant.
- lostlogin 10y agoThis is exactly the sort of repair that gets implemented - fixing the wrong thing!
- kilotaras 10y agoPresumably the original limitation is hardware that is actually counting axles, while timing check can be done programmaticaly.
- masklinn 10y agoIt is much safer to lock the segment on overflow or underflow (and require manual rearming), a timer can be defeated and dumb luck means it will eventually be.
- gsnedders 10y agoAlso Germany has a limit of 252, IIRC, and I expect the majority of long freight trains passing through Switzerland to be international services. There are plenty of old axle counters in operation around Europe because ultimately it's a limitation more in theory than in practice. Along with the steep gradients, you have to remember there's far more passenger services on the lines, so pathing constraints force freight services to be shorter (you can't have them accelerating that much slower than passenger services, or they start taking up a disproportionate amount of capacity on the line).
- SilasX 10y ago>Also Germany has a limit of 252 Was that itself a response to the exactly-256 problem, "plus a margin of safety"?
- gsnedders 10y agoYes. Plenty of European countries have similar limits, around 250. There's plenty of old 8-bit microcontroller based axle counter systems still in use which are unlikely to get replaced until they are life expired simply because the 256 limit incredibly rarely affects anything; for reference, the most axles per train in the UK I'm aware of is 192 axles.
- deleted 10y ago[deleted]
- Animats 10y agoSwitzerland runs small freight trains by US standards. Freight cars are usually 2-axle. Here's Union Pacific's longest container train. 295 freight cars, 9 locomotives. Four axles per car. So that's over 1180 axles. A more typical US train is 100 cars and a few locomotives; over 400 axles isn't uncommon. 256 would be an inadequate axle limit in the US. (There are longer trains in Australia, but they're usually coal or mineral hauls on dedicated track in flat country. This was a run from Los Angeles to Texas on mainline track.) [1] https://www.youtube.com/watch?v=jdIzRFOaTCY https://www.youtube.com/watch?v=jdIzRFOaTCY
- the_mitsuhiko 10y ago> A train having less than 256 axles in Switzerland doesn't exactly sound limiting It would appear the maximum length of a train in Switzerland is 1500 meters which would push it well above 256 axles.
- gsnedders 10y agoI'm only aware of one single movement of a 1500m test train, consisting of 76 container wagons and three SBB Re 620 locomotives, which would make 322 axles if I'm not mistaken, for the curious. At the same time, that was a run through the Gotthard Base Tunnel, and running onto similarly modernised infrastructure, and hence less likely to have 40 year old axle counters in use.