3 ms·
> A "bumpless" expansion joint is an unusual requirement, but one could probably be designed. Not just bumpless. It also has to be sealed against a large nega
by lisper 11y ago
> A "bumpless" expansion joint is an unusual requirement, but one could probably be designed.
Not just bumpless. It also has to be sealed against a large negative pressure differential. Those two requirements together take you into unexplored engineering territory.
> The SF BART tunnel under the bay has huge rubber expansion joints.
Not even remotely comparable. That tunnel is two orders of magnitude shorter than the HL, the walls aren't smooth, they don't have to sustain a vacuum, and the thermal gradients are much smaller underground.
> Two tubes slipping over each other with an interior lining of braided mesh might do the job
And what provides the vacuum seal?
> The expansion joint problem is probably solvable
Sure, but the interesting question is: can it be solved without prohibitive cost. The jury is still very much out on that.
> Emergency exits will be a big problem
Why do you think so? Pressure-sealed doors are a solved problem.
- Animats 11y agoThere are vacuum-rated expansion joints.[1][2] They have metal rings integrated into the flexible component to prevent inward collapse. Interior tube smoothness remains a problem. The Hyperloop air bearings float at only 1mm ± 0.5mm. Even fixed joints with that tight a tolerance are difficult. Anything other than plain tube (access hatches, etc.) will have to present a totally smooth inside. Not impossible, but runs up the costs. [1] http://www.ethylene.com/flexijoint.php http://www.ethylene.com/flexijoint.php [2] http://www.garlock.com/en/products/style-204-evs http://www.garlock.com/en/products/style-204-evs