3 ms·
My gut feeling about Aluminum foil is that because of the hard oxide coating it's difficult to get two pieces to make a continuous electrical connection along a
by Gibbon1 11y ago
My gut feeling about Aluminum foil is that because of the hard oxide coating it's difficult to get two pieces to make a continuous electrical connection along any length of it. And you can't solder to it.
My suggestion is to use copper tape or thin tinned copper sheet instead.
My other suggestion if hand prototyping is to use vector board with top and bottom ground planes. Note a lot of vector board designs are total crap. Either no ground plane or has 'power buses' The buses are horrible for grounding. The reason is you want the return current in any signal to travel in a ground plane under the wire. with a 'bus' the return current runs off down the bus creating a large loop.
Loops are bad, any magnetic or electrical field that the crosses the loop will induce noise.