3 ms·
Currently I'm loving the bondtech extruder and the E3D V6 hot end combination. Lots of control an very reliable in a wide variety of filament / control issues.
by ChuckMcM 12y ago
Currently I'm loving the bondtech extruder and the E3D V6 hot end combination. Lots of control an very reliable in a wide variety of filament / control issues. Building that as a 'direct drive dual extruder' on this platform might be challenging given the available space but you could probably get it to work in a bowden configuration with the hot ends on the print head and the extruders attached to the back of the case next to the spools.
For electronics there is currently a big debate over the Replicape/Smoothieboard type tradeoffs. All serious folks have dumped the AVR/Arduino stuff in favor of either ARM Cortex-M stuff or the Beaglebone Black (like a RasPi but with more I/O). Most folks prefer the higher power 8825 stepper motor drivers over the older 4498 versions. There is a challenge there however, that if you're trying to run your motors that hot you are probably over driving your printer. I've currently got a CRAMPS board with a Beaglebone Black as a controller in my 'new' build, and I continue to print parts as needed on my Replicator Dual (which was the last fully opensource printer Makerbot made).