5 ms·
Is there an upgrade path for electronics & extruders that you would recommend?
by kw_banks 12y ago
Is there an upgrade path for electronics & extruders that you would recommend?
- spiritplumber 12y agoMake your own extruder holder (it's usually the first thing that gets designed) and pick one that is easy to unclog. You'll eventually tune it to perfection. That's my experience anyway.
- ChuckMcM 12y agoCurrently I'm loving the bondtech extruder and the E3D V6 hot end combination. Lots of control an very reliable in a wide variety of filament / control issues. Building that as a 'direct drive dual extruder' on this platform might be challenging given the available space but you could probably get it to work in a bowden configuration with the hot ends on the print head and the extruders attached to the back of the case next to the spools. For electronics there is currently a big debate over the Replicape/Smoothieboard type tradeoffs. All serious folks have dumped the AVR/Arduino stuff in favor of either ARM Cortex-M stuff or the Beaglebone Black (like a RasPi but with more I/O). Most folks prefer the higher power 8825 stepper motor drivers over the older 4498 versions. There is a challenge there however, that if you're trying to run your motors that hot you are probably over driving your printer. I've currently got a CRAMPS board with a Beaglebone Black as a controller in my 'new' build, and I continue to print parts as needed on my Replicator Dual (which was the last fully opensource printer Makerbot made).