4 ms·
The issues with part flex during the build process seem inherent to the "printing" technology. I wonder if the best way around this for metal might be to print
by jessaustin 12y ago
The issues with part flex during the build process seem inherent to the "printing" technology. I wonder if the best way around this for metal might be to print a wax (or similar material) part, and then cast. Lost-wax casting would be difficult for the consumer, and if I'm to believe "How It's Made" is largely handwork even in industry. However, it might also be a process that could be improved by new, programmable tools.
- VLM 12y agoCasting has similar entertaining issues with shrinkage and voids and embedded stresses. The thin parts and edges will cool much quicker than the edges. You could anneal a block, and EDM the whole thing. Probably cheaper than the powder processes at this time and certainly the end result will either be lighter or stronger. What does work w/ 3d printing and casting is printing your model in PLA or whatever, then sand casting around it, at least if its small. If its big you still win on time (and probably cost) using traditional woodworking to make the model.
- hengheng 12y agoActually part flex during the build process is much more of a problem with milling and sometimes turning. There simply is a set of "forbidden" geometries where the tool would destroy the part, so nobody does them. The difference, as OP states in their article, is experience and craftsmanship.
- lotsofmangos 12y agoIn a similar vein, I've been thinking about trying to 3d print casting sand.