4 ms·
You can do it, but it turns out the work to pump water up to 1400 psi in a pressure vessel before it goes through a reverse osmosis membrane is about the same a
by colechristensen 12y ago
You can do it, but it turns out the work to pump water up to 1400 psi in a pressure vessel before it goes through a reverse osmosis membrane is about the same as the work to pump desalinated water up from the bottom of the ocean at 1000 meters. There are different inefficiencies in each situation, but I'd assume maintaining equipment 1km below the sea would trump them all.
- cma 12y agoI think he really means you bail the water from the top rather then pump it, leaving an airgap at the top that the pressure from below gradually fills with more water through the membrane. But then again unless you bail all the water, that leaves only a small pressure differential, and if you bail it all, it gets less efficient as it fills back up and the pressure differential gradually reduces and lifting it from the bottom takes a lot of energy :P. Yeah, I don't understand what he's getting at with the design.
- ChuckMcM 12y agoAs described in the paper the top 20 meters of the pipe to the surface are emptied (the paper refers to a 30 meter 'pump head' which I believe is the distance below the surface that the water has been pumped out of the pipe). The part on the surface of the ocean is what looks like a giant bucket of sand on the outside (it is supposed to be below the level at which coral grows). The pipe fills with fresh water at some rate (unspecified by the paper) and you can pump it out at the top when you need it. The part on the bottom of the ocean requires no maintenance.