4 ms·
First, if you have no mechanical inclination and don't have mechanical friends, then used cars are problematic. Although you probably be in worse shape buying
by protomyth 12y ago
First, if you have no mechanical inclination and don't have mechanical friends, then used cars are problematic. Although you probably be in worse shape buying a new car also. The second problem now is an awfully lot of used cars and used car parts got trashed by the "cash for clunkers" program. I can think of few worse government programs to put the boot to working folks then that program.
Its all risk management. Not much different from the buy vs build in computing. Sadly, mechanical training is a dying skill and the risk is much higher.
My co-worker just bought a used Subaru for $1,000 and other than needing a belt replacement ($60 and about a hour of time), it was in really good shape. He knows how to look at a car, so all good.
Always, always, check the timing belt (or chain) and oil pump on old vehicles. That repair will kill you.
- gknoy 12y ago> Always, always, check the timing belt (or chain) and oil pump on old vehicles. How? I'm assuming you mean when evaluating a used car to buy. Do I say "I need to have my mechanic check this...", or is there some kind of car-health certification I should be lookinf for? I wouldn't even know what to look for if checking under the hood myself.
- protomyth 12y agoThat's were the mechanic friend comes in :) They should have some sort of maintenance log or shouldn't be offended if you want a mechanic to check it before you buy. If it has over 60,000 miles it better have been inspected and at about 90,000 miles it should have been replaced. This varies by car. A car with an Interference engine will blow up if that belt breaks. Engine replacements are not cheap. A good hint on how things are, open hood, look at belt (this is not the timing belt). Does it have pits? Does it look really worn? If it is, I would make a bet that proper maintenance isn't being done. It is slightly harder than basic fluid maintenance. If you're uncomfortable with all of that, then buy a certified pre-owned from a decent dealer.
- chiph 12y agoSometimes mechanics will write the date they changed the belt on the cover. Other times you have to look for tool marks on the timing belt cover and/or crankshaft pulley. But the best way is to have paperwork showing it's been done. If none of the above are definitive, go ahead and pay to have it done - it'll be far cheaper than if the belt breaks.
- driverdan 12y agoI don't understand how someone can drive but not know basic car maintenance, especially if you can only afford an older used car and depend on it. I don't mean everyone should know how to replace a clutch but you should know the basic wear components (filters, belts, lights, brakes, etc) and how to diagnose and replace them. On most cars these are fairly simple (except on some newer cars that make them overly complex). This is a rule I feel should be applied to your entire life. At a bare minimum you should understand the basics about things you use on a daily basis. Computers, cars, homes, etc.
- mschuster91 12y ago> I don't mean everyone should know how to replace a clutch but you should know the basic wear components (filters, belts, lights, brakes, etc) and how to diagnose and replace them. F..k Renault. Lights on these (especially Laguna front lights) tend to be an adventure to replace. Or every car with the high-voltage Xenon gas lamps. I was pretty happy with my VW T4, I could tear that car down and reassemble without any problem. With modern cars, filled with dozens of computers, not so. And to make things worse, once one of the computers or sensors breaks or has issues, you'll need OBD diagnosis computers or even specialized computers to diagnose the problem or repair it. That's stuff for expensive maintenance shops, while I just needed a small garage and a couple of basic tools for the T4 (okay, and a motor crane for lifting out the engine).
- driverdan 12y agoYup, that's why I said except on some newer cars. Headlights were what I was thinking about too. Even some non-HID headlights have become a real pain to replace.
- mschuster91 12y agoThe problem with the headlights is crash resistance. Old(er) cars had plenty of space available in the engine room because the "air" was used to absorb impact in crash situations. New materials/manufacturing processes allow for entire removal of "dead space", with more and more components for "luxury" stuff (luxury compared with an old car, like all-side radar, active parking assistants, multi-zone AC,...) squeezed in every cubic centimetre of the car. And so, no more space is left for your hands when you try to replace a f...ing 4mm wide lamp. Unless you disassemble the container for the window washing fluid, unmount the brake fluid container and bend two multi-wires (Renault Laguna, right-front lamp assembly).