3 ms·
Are they ignoring the FCC's EIRP maxima (and beamforming penalty) on the 2.4GHz ISM band? If they aren't, they can still get 1W theoretically, which is actuall
by jrockway 12y ago
Are they ignoring the FCC's EIRP maxima (and beamforming penalty) on the 2.4GHz ISM band?
If they aren't, they can still get 1W theoretically, which is actually useful: it can kind of charge your phone in 8 hours. Assuming 100% of the power is captured by the antenna, that is. (Note that I say theoretically: the real world is very bad for theoretical models.)
Also something to worry about: the FCC's maximum permissible radiation exposure. For 6 minute controlled application (people near the transmitter know it's on), you're allowed an energy density of 5mW per square centimeter. An iPhone 4 is about 55 cm^2, so that would mean a maximum of 275mW. That would charge the phone in 24 hours. (These are guidelines for amateur radio operators, not Part 15 devices; I don't know what the regs around Part 15 say about power density. The regs also cover far-field effects, not near-field effects, so perhaps they can get around these.)
Finally, if you want to play with beamforming and figure out how to get 100% of the power to a 55 cm^2 area, try: http://apenwarr.ca/beamlab/ http://apenwarr.ca/beamlab/
- andruby 12y ago2.4Ghz is only used for the bluetooth communication, not for the power transfer. That happens at 5.7-5.8Ghz. "What are the RF spectrums being used by WattUp?" [1] - 2.4GHz (Unlicensed) for Bluetooth Low Energy communication - 5.7-5.8 GHz (Unlicensed Industrial, Scientific & Medical, ISM) band for power transfer" [1] http://www.energous.com/page-f/ http://www.energous.com/page-f/
- jrockway 12y agoSame EIRP regulations and RF safety regulations for all ISM bands, as far as I can tell. (900MHz has a slightly difference RF exposure calculation that you have to do compared to 1300MHz and up. But 2.4 and 5 are the same.)