2 ms·
Most 3D panels use an array of lenticular lenses to convert incident angle to position[1]. Note that the 3DS actually uses a parallax barrier, which is similar
by aidenn0 12y ago
Most 3D panels use an array of lenticular lenses to convert incident angle to position[1].
Note that the 3DS actually uses a parallax barrier, which is similar to this, but with the stripes far enough out-of-plane to the image to allow each eye to see a different part of the image[2].
The book my daughter has works just like this website, with black stripes on a transparent layer, and a layer immediatly below that is attached to the spine, but not the outer layer, causing it to move relative to the stripes as the page is turned[3].
1: http://en.wikipedia.org/wiki/Lenticular_printing http://en.wikipedia.org/wiki/Lenticular_printing
2: http://en.wikipedia.org/wiki/Parallax_barrier http://en.wikipedia.org/wiki/Parallax_barrier
3: No good wikipedia article, so here is their about page http://scanimationbooks.com/about-scanimation/ http://scanimationbooks.com/about-scanimation/