4 ms·
Why do you doubt the temperature did not reflow the board? When I solder electronics, I'm usually somewhere between 500F to 650F, but that's so things get hot
by Alupis 12y ago
Why do you doubt the temperature did not reflow the board?
When I solder electronics, I'm usually somewhere between 500F to 650F, but that's so things get hot enough quickly enough to not burn. I don't doubt a slow bake at 340F would do the same thing... some online googling shows people doing reflows with toaster ovens in the same temperature range (340F-450F).
It's likely the solder joints were not completely disconnected, but rather simply cracked. So heating them a bit would allow the crack to reconnect, at least for a short while (seems to explain his symptoms of repeated failures after extreme system temperatures during operation).
- Justsignedup 12y agoIs it not true that baking it makes any "cracking" in the soldering smooth out since this is similar to what is done to boards at the factory during construction?
- jamesaguilar 12y agoRight. And the reason why it keeps breaking? Well, the solder on the board might not have any flux left, so it might have trouble flowing properly. There could be a cold joint, etc. If it fails again, one possible next step would be to grab a multimeter and test the resistance across each component on the board. If the resistance is infinite, that might be your problem component.
- niels_olson 12y agoDon't you have to isolate components from the circuit to check resistance? Otherwise, you're looking also the other components look like the other arm(s) of a parallel circuit.
- jamesaguilar 12y agoYou know what, you're right. I saw a video of someone testing that a chip had been soldered on correctly with a multimeter, but he was testing for the lack of a connection. Testing for a connection would not be done this way.My bad.
- fest 12y agoThere's more than resistors on logic board. Also, by even touching component leads with multimeter probes is sometimes enough to connect the joint back thus fooling you to think connection was ok. Also, the problem might as well be one of the numerous chips in BGA packages whose connection points you can't even see, let alone- probe.
- rasz_pl 12y agophysics, 340F will NOT melt solder
- zymhan 12y agoGot a source for that? According to Wikipedia, 340F is not far from the melting point for solder. Depending on the solder used, it may have melted, or just gotten soft enough to heal any gaps or cracks. https://en.wikipedia.org/wiki/Solder#Lead-free_solder https://en.wikipedia.org/wiki/Solder#Lead-free_solder
- swimfar 12y agoThe link you attached lists a few different lead-free solder alloys with the lowest melting at 412F(211C) well above 340F(171C). Eutectic tin/lead solder has a melting point of 361F(183C), also above 340F. I'm not sure whether or not cracks can heal at temperatures below the melting point, but I would be surprised if that were possible.
- mmazing 12y agoSo it turns out that home oven manufacturers don't care too much about precision when it comes to oven temperature (and it doesn't matter usually). A high end home oven will easily swing between +- 25 degrees of the temperature that you have dialed in, and that's if it's well calibrated. If he didn't dial in "340" quite right, and his oven was average, I can easily see it hitting temperatures of 412+, and that could also account for his varied results.
- Alupis 12y agoNot to mention we don't need the solder to completely melt, only soften (depending how badly cracked the joint(s) were). If this were Mythbusters, we'd call it "Plausible".