4 ms·
I really love that you can get a power amplifier for the 5Ghz RF for about $2.
by ChuckMcM 12y ago
I really love that you can get a power amplifier for the 5Ghz RF for about $2.
- a1k0n 12y agoThe VCO (HMC431LP4) seems to be more like $20, though. edit: should have read the rest of the article after the schematic where he says as much
- VLM 12y agoIts about the right price for +20dBmW at 6cm. minicircuits.com has several MMIC in that freq range at that output power. Transcom sells a nice well over 30 dBmW MMIC for that same freq band... you can buy a kit from minikits in australia, the EME141-5800, the bare chip is like $20. Some ham radio work shows you don't need the fancy 4 layer weird oshpark material for workable stuff in that general freq range. http://www.w1ghz.org/MBT/multiband.htm http://www.w1ghz.org/MBT/multiband.htm As an interesting extreme opposite comparison, there was a B-29-ish era chirp radar altimeter for aircraft landing which was almost entirely mechanical. A little buzzer/motor thing varied the size of a resonant cavity by a little bit, and the resulting audio signal was turned into a voltage / altitude using something like a capacitor/resistor bridge. So one vacuum tube, a resistor, a capacitor, a diode mixer, and a meter (and a lot of plumbing) If you'd like better antennas around that range, yet again, just ask a ham radio guy. Its a very awkward freq band where dishes, and most importantly dish feeds, are huge compared to 10 or 24 GHz band, but a loop yagi like you'd use at 2 GHz or lower would be ridiculously small. The microwave ham radio contester guys seem to like horn antennas at that band so couple it into a moderately large waveguide and attach the (homemade) waveguide to a (homemade) horn antenna.
- mng2 12y agoWhat costs money is the spectrum analyzer, network analyzer, and Microwave Studio license.
- bsder 12y agoExactly. Testing RF is a PITA because the test equipment is so stupidly expensive.
- Animats 12y agoYes. Back in the 1990s I built a little LIDAR system using much the same principle as this system - modulate the output beam with a 20MHz carrier, down-convert at the receive end using the same local oscillator like an FM receiver, and measure the phase shift between the down-converted output and input. That transformation is phase-preserving, and the phase shift at the lower frequency represents the range. It wasn't hard to build. But I didn't have the test equipment to adjust it.