4 ms·
Excellent build quality, but I was surprised by these two statements on things you need: A decent soldering iron. You will thank yourself later. Also note:
by moron4hire 12y ago
Excellent build quality, but I was surprised by these two statements on things you need:
A decent soldering iron. You will thank yourself later. Also note: you will burn yourself many times throughout the build. Might as well do it with a fancy iron!
LEADED SOLDER – I started the build without leaded solder and oh dear…
If you have a "decent soldering iron", then lead-free solder shouldn't be a problem. Also, if you live in the EU, leaded solder will be extremely difficult to come by.
Well, even with a really crappy iron, as long as the tip is fresh, you shouldn't have a problem. Most people's problems with soldering come from not having the tip wet enough and not using enough solder, thereby not making enough contact with the wire and not putting heat into it fast enough to get that specific location hot before the heat conducts away into the rest of the wire.
Remember, the entire reason we're using the wire is because it's an excellent conductor. For that reason, thicker gauge wire is also going to be more difficult to work. And the only reason to use larger gauges of wire is to support more current. Keyboards run on extremely little current already. You probably could have done this with magnet wire and been fine (though I wouldn't recommend it, magnet wire is difficult to work for different reasons).
So crank up the heat. Get it into the wire as fast as possible. Lead-free solder generally needs higher heat than leaded solder anyway. Apply the solder, apply the wire, then wait a second before removing the iron, because you also have to heat the wire you're pushing in. Soldering is a chemical bond, the metals physically mix, and you need to get them up to the right heat to do that.
And keep it steady, any movement while it is cooling will create microfractures in the solder joint.
- gurgus 12y agoThanks for the tips! I found it very difficult to do the soldering due to an extremely unsteady hand and not a whole lot of experience. I 100% agree with everything you're saying though - I just ran with what I thought worked.
- michaelt 12y agoIt looks, in the photos, like you were trying to solder together two diode leads in mid-air. The trick to soldering when you have unsteady hands is to set things up so if you press harder the two things being soldered make better contact, instead of being pushed apart. That way you can rest the tip of the iron on the workpiece. Soldering leads together in the air can be a right pain, because you can't press on hard without them moving apart. You can usually find tricks to avoid it though - like putting an old PCB and some packing material below the joint, so you have something to push against, and twisting the leads together so they can't move apart as easily.
- ctz 12y ago> Also, if you live in the EU, leaded solder will be extremely difficult to come by. Source. I live in the EU and 60/40 is still the most common solder for hobbyists, and is sold everywhere.
- mng2 12y agoLet me add: another important part of soldering is understanding flux. Most spools of solder are not just lead/tin/etc, they include some chemicals that eat away the oxide layer on metals so that the solder can better adhere. When you solder to a PC board you get a pool of goop around the solder pad; this is the flux. When soldering in the air, it is harder for the flux to go where it needs to go. When soldering wires/leads to each other, it helps to apply flux beforehand, say with a flux pen.
- lgeek 12y agoLeaded solder has better wetting properties, it can be soldered at lower temperature and it's more reliable for joints exposed to any mechanical stress, including from vibrations and thermal stress. Any way you put it, it's superior to lead free solder and it's still widely available everywhere, including in the EU. No reason not to use it for stuff that isn't going to be sold.