3 ms·
At the time (and this was 2000, not today) TSMC had a 'boiler plate' for most FPGA families, which was the silicon and metal layers were already done, and all y
by ChuckMcM 12y ago
At the time (and this was 2000, not today) TSMC had a 'boiler plate' for most FPGA families, which was the silicon and metal layers were already done, and all you needed to supply was the interconnection layer (which was generally all metal). The advantage was the single mask versus a full set. The downside was that it wasn't as compact as it could be, but this was essentially 'fpga -> asic' minimum cost, and at the time the FPGAs themselves were quite expensive chips. So if you had designed something you could do this to convert to an ASIC and then pop out a more cost effective version. That changed with the 90 nm node I believe (Xilinx had a bunch of 'Kiss your ASIC goodbye' type advertising at the time) where they had gotten the cost of the FPGA down below even this sort of inexpensive ASIC.
If you are all in, you just hand over your HDL code and test vectors and they crank it through on your process of choice, and poof out comes chips. At which point you are exactly a fabless semiconductor company :-).