4 ms·
IMO ARM is kind of a wash when it comes to NAS - with modern chipsets most of your power goes to keeping the disks spinning. My C2550D4I file server build I jus
by XorNot 12y ago
IMO ARM is kind of a wash when it comes to NAS - with modern chipsets most of your power goes to keeping the disks spinning. My C2550D4I file server build I just completed uses about 60W in idle. By my calculations ~40 or so of that is the power used by the 8 disks plus SSD boot drive.
x86 chips are more then suitable for the application since you're no longer in "ultra ultra low power" territory (and for ZFS, are beneficial because you want those checksum calcs to finish fast).
- voltagex_ 12y agoCan the disks spin down at all in your set up? I've been looking at those processors for a while (Intel Avoton C2550). Was there any advantage to going up a few models in that series?
- vomitcuddle 12y agoI agree, but I can buy two entry-level Synology DiskStations for the price of one C2550 CPU+MB bundle. I really like that CPU and I would buy it in a heartbeat to replace my Synology, if the price didn't include the "GenuineIntel tax".
- rjsw 12y agoWhen I bought it, my HP MicroServer cost less than any equivalent ARM NAS, it has ECC RAM too.
- XorNot 12y agoSame. I went that route because a NAS of any appreciable capacity was going to cost more for the box and no disks then my entire setup put together.
- uxp 12y agoI also went with an HP MicroServer, but only just heard about their somewhat recent policy change of requiring a valid warranty or paid service plan to obtain firmware and software updates. http://www.zdnet.com/hp-to-begin-charging-for-firmware-updates-and-service-packs-for-servers-7000026110/ http://www.zdnet.com/hp-to-begin-charging-for-firmware-updat...