4 ms·
Already done. When I worked in EVs we used a HybridPack2 power module from Infineon. It's about the size of a sandwich but longer, and skinnier. You add a drive
by phkahler 12y ago
Already done. When I worked in EVs we used a HybridPack2 power module from Infineon. It's about the size of a sandwich but longer, and skinnier. You add a driver board, a logic board, a capacitor, connectors, cold plate. It's about the size of a shoe box and can deliver 100kW continuously. I pushed one under ideal conditions to 200kW.
Of course, liquid cooling means a total system that is quite a bit larger than I describe. In order to get rid of liquid cooling at that power level you'd have to get the losses down by a huge margin. We were dissipating 2-3kW at high power, so for air cooling you'd need to get that down by a factor of at least 10. The only way to drive the heat down like that is at the semiconductor device level.
This is a challenge that everyone in the field is already aware of and working on, while people outside the field have no ability to do meaningful research.
At the small scale, an Arduino with the mega-moto shield can push some hundreds of watts in a few cubic inches. So what exactly is the challenge?
- fryguy 12y agoThe challenge is getting AC current, not DC as with the mega-moto shield.
- phkahler 12y agoTypically you want AC on the input or output and DC on the other. You can use that shield to produce AC by driving the outputs with PWM (it is intended for that). If there was a 3rd channel on the mega-moto, you could drive a 3-phase AC motor with it. If you put a transformer on it, you can connect it to the line and do DC->AC or AC->DC. Normally we want the DC voltage to be higher than the AC, so it's not the ideal shield for line connection - hence the transformer instead of simple inductors. And yes, the inductors add to the size, but if you are driving an inductive load like a motor, they are normally not needed.