3 ms·
Jeez People (especially on kickstarter) think that if they have a pretty 3D drawing of the thing the hardware is going to be a breeze. Oh and they're going to
by raverbashing 12y ago
Jeez
People (especially on kickstarter) think that if they have a pretty 3D drawing of the thing the hardware is going to be a breeze. Oh and they're going to use Arduino for it
Funny. Not.
I think Arduino made people think "everybody can work with hardware now wohoo!!" Oh but they don't know Ohm's law.
"We quickly learned that there was no concept of “off the shelf” when manufacturing in China."
Well, of course there is. Unless the existing parts don't fit your project. Then you'll need a lot of parts specd for your need. Tip: don't do that.
You'll already have to do the case, circuit board and maybe power source, this is enough trouble. Add in mechanics and you're in for a tough ride.
I've seen hardware bugs in reference implementations from people that should've known better. Manufacturing reliability is always lower than you think it is.
- bravo22 12y agoAgree 100%. Another common approach to further mitigate manufacturing reliability issues is to contract a single vendor to make and assemble the mechanical unit. Basically everything from input shaft to output shaft goes into a box. You put the motor in and build a contraption to measure the output torque, etc. You only pay them for units that actually pass the test. The failed units are their problem. Look at the price they'll quote you for this and you'll know how reliable they really think their process is.
- sliverstorm 12y agoOh and they're going to use Arduino for it Well, shit, that means they are like 95% done right? The silly thing is an Arduino bypasses possibly the easiest part of a microcontroller project. While they do have some convenience, if you need an Arduino you have no business tackling a sophisticated electrical project...