4 ms·
I'd never use any router provided by an ISP. Use your own router and their device as a next step DHCP server.
by shmerl 13y ago
I'd never use any router provided by an ISP. Use your own router and their device as a next step DHCP server.
- moondev 13y agoNot an option with uverse unfortunately. The router and modem are combined into a single box.
- jrockway 13y agoI have Time Warner (but probably a very similar device) and the wireless setup GUI lets you put the router into bridged mode. Good enough.
- ben1040 13y agoAdmittedly it's been a while since I have had U-Verse, but I was able to disable wifi on the modem, put the modem in "DMZ mode," and make an Apple Airport Extreme work well with it. Still not real bridged mode, although the router behind the U-Verse modem in DMZ mode would get the real external IP address handed to it so it doesn't act like a double-NAT situation. You still had to have your TVs run through to the actual U-Verse modem, though, and can't plug them into a router sitting behind it.
- coin 13y agoWhat's wrong with double NAT?
- smtddr 13y agohttp://graemenoble.id.au/post/48695277030/double-nat-explained-and-possible-solutions http://graemenoble.id.au/post/48695277030/double-nat-explain... Nothing really, but you should generally avoid it if possible. It just creates the possibility of having unexpected problems later on.
- crummy 13y agoDouble port forwarding, for one.
- chomp 13y ago> You still had to have your TVs run through to the actual U-Verse modem, though, and can't plug them into a router sitting behind it. Yeah you can. I have Uverse Router ==> PFSense Box ==> GigE switch ==> Uverse TV box. The trick is enabling IGMP proxy. The first 10 seconds of a Uverse TV stream is transmitted over UDP. After 10 seconds, it switches to multicast. You need IGMP proxy on the PFSense box (or IGMP proxy capable switch) to relay that multicast traffic to the ports on the other interface. After that, DMZ your PFSense box, add just a few firewall allow rules, and you're done!
- ben1040 13y agoAh, that's right, now you're jogging my memory as to why it didn't work for me. My consumer level router I had at the time wasn't capable of doing the IGMP proxy. Out of curiosity I looked and my Asus RT-N66U does in fact offer it, so more consumer routers may be directly compatible now too.
- hahainternet 13y ago> The first 10 seconds of a Uverse TV stream is transmitted over UDP. After 10 seconds, it switches to multicast What the heck? Do you have any clue what the motivation is behind this?
- chomp 13y agoYeah like tacoman said, it's for channel changing. Multicast saves on bandwidth.
- tacoman 13y agoIt's how they deliver instant channel change. The unicast udp burst is about 30% higher than the nominal bitrate of the multicast. The STB stitches the unicast and multicast together seamlessly.
- hahainternet 13y agoThat is an impressively smart solution really. I don't have instant channel change :(
- reboog711 13y agoMy UVerse Router is the "entry" point into my system. but, everything else is behind a Cisco RV042, which routes around static IP Addresses. More info on my setup here: http://www.jeffryhouser.com/index.cfm/2012/3/26/How-can-you-use-Static-IPs-with-ATT-UVerse-Service http://www.jeffryhouser.com/index.cfm/2012/3/26/How-can-you-... I also have a Wifi Router plugged into the RV042, so Wifi is completely turned off at the UVerse router.
- eddieroger 13y agoMy U-Verse provided box has my Airport Time Capsule connected via Ethernet and it's MAC put in the DMZ. From there, the Airport is my network gateway. It was a little bit of a challenge to setup, but is possible.
- kylec 13y agoI agree. You don't even need the Actiontec router at all with FiOS, at least for internet - I plug my Airport Extreme directly into my ONT and have had zero issues with this setup.
- rootbear 13y agoDid you have to get Verizon to switch the ONT to Ethernet instead of coax? My understanding is that only one of those was live at any given time. I've been thinking about replacing my Actiontec with something better (I have the older 802.11g version) and this article has encouraged me to act on that.
- kylec 13y agoI didn't ask them to do anything special, they must have automatically done it when setting up my service. My ONT is inside my apartment, though, so that might make a difference.