3 ms·
"If you answered “Yes” to this last question, then you just experienced the Illusion of Understanding first-hand." Bzzt wrong it could mean you're thinking lik
by VLM 13y ago
"If you answered “Yes” to this last question, then you just experienced the Illusion of Understanding first-hand."
Bzzt wrong it could mean you're thinking like an engineer instead of a scientist. And its not binary, so fuzziness would be partially one or the other reason at the same time.
Possible engineering challenges all contributing a really small delta, all of which add up to so few sig figs a good engineer can't predict what will happen to the water level:
1) You don't know how well mixed the cup is. I assure you, especially on the "summer day" in the article you can get a spread of 20 or more degrees in that cup. So the liq at the bottom is already way past the max density temp and expanding while the top still has some ice.
2) You don't know the starting temp of the water and ice. In addition to #1 above, the ice in my freezer is well below 32 and who knows the starting temp of the water. Maybe its barely melted meltwater or maybe its out of the tap or maybe the coffee maker. So its going to go thru some wild temp and density swings based on unknown initial conditions.
3) The pix shows massive condensation on the glass AKA they're running the experiment in New Orleans not Phoenix also in written form they're running it in the summer. Realize that there's nothing magic about surfaces and condensation... if a sq inch of 32F surface condenses 1 teaspoon per 5 minutes, the top will condense just as well as the sides. On the other hand if you run this in an environment with a dew point below 32F like where I am today, then water will steadily evaporate away depending on the intensity of energy striking the surface, although not too fast.
4) Ice stacks up nicely and clogs pipes. So you'd need more like a slushy to make sure that icecubes are not mechanically sticking up above the surface by being jammed by the cup walls. The supplied pix strongly indicates the middle ice cube is mechanically jammed way above flotation level. One thing for sure, liquids don't have much shear strength and thats going to eventually melt and drip down and raise the water level... how much, who knows.
5) How does water surface tension vary WRT temp? I donno. Probably does, a little. So how much the level can go up or down before it drips is a mystery. You might be able to tolerate a rise of 0.1% if the surface tension enables a "lens" above the top of 0.2% because of increased temp. Or maybe it goes the other way and surface tension drops so "just barely overflowing" at 32F means a flood (well, at least a drop...) at a liquid temp of 40F.
Its probably possible to very carefully engineer the perturbing contributions to a low enough, or counteracting against each other enough, level (oh the pun) such that the science principle will be demonstrated. Or given way the heck more engineering data, a properly engineered answer might be provided, maybe with enough sig figs to mean something. Or maybe not enough sig figs to mean anything. I'm feeling the latter.