4 ms·
The smaller the aperture, the more diffracted incoming light rays. Once the 'circle of confusion' or airy disc exceeds the size of a single pixel on the sensor,
by hahainternet 13y ago
The smaller the aperture, the more diffracted incoming light rays. Once the 'circle of confusion' or airy disc exceeds the size of a single pixel on the sensor, you begin to lose lens sharpness. If you imagine two strips of paper, one green, one blue, directly adjacent. Now imagine photons from either side of the adjacent edge passing through a lens which slightly diffracts them.
This results in an obvious merging of the blue/green strips. The more the diffraction the more they merge, the less sharp the images become.
Current APS-C sensors at 18 megapixels have pixels small enough that an aperture of around f/11 is the minimum size before this effect begins. As sensors get more and more dense, the required aperture size gets larger and larger. F/8 is considered a 'normal' aperture and once sensors hit that density then the payoff from increased resolution is significantly less and can impact image quality adversely.
This is why science missions use 2mp CCDs that they know the characteristics of, rather than some 40 megapixel phone sensor.
edit: I've just realised I've typed all this out with the wrong idea. You wanted a simple explanation of diffraction. Imagine a water tank with waves being generated from a source at one end. Put a wall with a narrow hole in the middle of the tank. If the wavelength of the waves is significantly less than the width of the hole, they will for the most part pass through unaltered. As the hole gets smaller, more significant changes to the waves occur. They begin to 'spread out' or 'diffract'. An intuitive explanation is difficult but this is a practical one that makes sense to people.
- josu 13y agoThank you, for both explanations, that was very informative.
- kika 13y agoScience missions use 2mp CCDs mostly because of the sensitivity. The larger is the individual sensor ("pixel") the more photons it can absorb thus more electrical potential it can generate compared to the noise level. There's also technological barriers for creating large megapixel CCDs as opposed to CMOS. Large CCDs are usually created by "stitching" multiple sensors together, which increase their price as a square of the size. You can shoot fullframe (35mm) camera at ISO 25600 and get decent results, but if you crank up signal amplification on iPhone to 25600 you'll get nothing but random color dots :-)
- hahainternet 13y ago> Science missions use 2mp CCDs mostly because of the sensitivity It would be foolish to suggest there was a single motivator for inclusion of a sensor. In reality it is a combination of our answers. Large sensors allows lower gain and better noise performance, enables smaller aperture use at acceptable sharpness, takes less resources to process, transmit etc. You're not wrong in mentioning it though. Although FF at 25600 is going to be piss poor even if it's Nikon / Sony. edit: corrected stupid misspelling
- kika 13y agoYou've got very high standards in image quality :-) Nikon D600 at 25600: http://www.imaging-resource.com/PRODS/nikon-d600/nikon-d600GALLERY.HTM http://www.imaging-resource.com/PRODS/nikon-d600/nikon-d600G... Not even close to "piss poor" in my book.
- ygra 13y agoThat's about the noise level and sharpness I have on my EOS 40D with ISO 1600. I think I'm going to cry in a corner a little. That being said, you don't go that high unless you're very desperate and the sensor itself can go up to 6400, the rest is software.
- ygra 13y agoSample image if needed: http://fc07.deviantart.net/fs71/f/2010/032/f/e/City_Lights_by_jo_i.jpg http://fc07.deviantart.net/fs71/f/2010/032/f/e/City_Lights_b... That was f/32. The rings around the street lamps are diffraction artifacts.