3 ms·
#define REG_08_POWER_DOWN 0x36 // 0011 0110 // |||| |||| // ||
by robomartin 13y ago
#define REG_08_POWER_DOWN 0x36 // 0011 0110
// |||| ||||
// |||| |||Power Down: 0 = Power down// 1 = Normal operation
// |||| ||Edge Select: 0 = Falling edge// 1= Rising edge
// |||| |Input Bus: 0 = 12 bits// 1 = 24 bits
// |||| Dual edge: 0 = Single edge// 1 = Dual edge
// |||H-sync enable: 0 = Always low (no H-sync)// 1 = Transmitted
// ||V-sync enable: 0 = Always low (no V-sync)// 1 = Transmitted
// Reserved
#define REG_08_NORMAL 0x37 // 0011 0111
// |||| ||||
// |||| |||Power Down: 0 = Power down// 1 = Normal operation
// |||| ||Edge Select: 0 = Falling edge// 1= Rising edge
// |||| |Input Bus: 0 = 12 bits// 1 = 24 bits
// |||| Dual edge: 0 = Single edge// 1 = Dual edge
// |||H-sync enable: 0 = Always low (no H-sync)// 1 = Transmitted
// ||V-sync enable: 0 = Always low (no V-sync)// 1 = Transmitted
// Reserved
#define REG_09_NORMAL 0x21 // 0010 0001
// |||| ||||
// |||| |||Monitor detect interrupt: (MDI) 0 = Detected// 1 = Clear/Not detected
// |||| ||Hot plug detect: (HTPLG) READ ONLY
// |||| |Receiver sense: (RSEN) READ ONLY
// |||| Interrupt generation method: 0 = MDI generated by RSEN// 1 = HTPLG
// |MSEL output pin source selection: (MSEL[2:0])
// | 000 = MSEN always high
// | 001 = MSEN = MDI bit
// | 010 = MSEN = RSEN bit
// | 011 = MSEN = HTPLG
// | 1xx = RESERVED
// VREF setting indicator: (VLOW) READ ONLY
#define REG_0A_NORMAL 0x10 // 0001 0000
// |||| ||||
// |||| |||Reserved
// |||| General purpose inputs (same as CTL[3:1] pins)
// |||De-skewing enable: (DKEN) 0 = Disabled// 1 = Enabled
// De-skewing setting: (DK[3:1])
// 000 = 1 step minimum setup/maximum hold
// 001 = 2 steps
// 010 = 3 steps
// 011 = 4 steps
// 100 = 5 steps default (recommended setting)
// 101 = 6 steps
// 110 = 7 steps
// 111 = 8 steps maximum setup/minumum hold
#define REG_0C_NORMAL 0x89 // 1000 1001
// |||| ||||
// |||| |||PLL Filter Enable: 0 = Disable// 1 = Enable
// |||| PLL Filter characteristic: 100 = recommended value
// |Reserved
// Sync Continuous: 0 = Disable// 1 = Enable (recommended)