I’m working on integrating with a Jeep Renegade which was designed on the Fiat small-wide platform, and the CAN bus architecture is a non-starter for mainline O

I’m working on integrating with a Jeep Renegade which was designed on the Fiat small-wide platform, and the CAN bus architecture is a non-starter for mainline OpenPilot support. OpenPilot requires every signal needed from/to the car is accessible by tapping at most two CAN buses, both of which must be accessible on the cable to the lane assist camera behind the rear view mirror. On the Renegade, the adaptive cruise control activation and control signals are on a separate bus from the steering control signals, and the ACC signals don’t get up to the lane assist camera at all. OpenPilot support on this vehicle will require tapping CAN buses in two spots on the vehicle, and this is not a Comma-supported configuration. They want to be able to make a single interposer cable that plugs in between the lane assist camera and your car, and if that’s not possible they will never support your vehicle. To attempt to support my car I am working on a gateway device that will bridge information from the powertrain bus to the fusion bus so it will be available at the camera (which is on the fusion bus and the chassis bus). But this implementation, which may not actually work but even if it does, will never be accepted upstream. And safety-wise, that’s probably the right choice for the project. The sad part is I think the only signal that I need that I don’t have at the camera right now to make a safe implementation is ACC engagement. I’ve scrutinized every bit of every message on the chassis and fusion buses available at the camera and there is simply no signal that indicates if ACC is engaged. One bit is all I need to get lateral control working. Well, assuming that once I start injecting control signals there aren’t other issues, that is. And that is not probably a safe assumption.