4 ms·
i imagine the special filament might only be needed for a layer or two (assuming the board contact surface is the top or the bottom that is)?
by sleepybrett 1y ago
i imagine the special filament might only be needed for a layer or two (assuming the board contact surface is the top or the bottom that is)?
- ImPostingOnHN 1y agoIt might be easier to 3d print normally, then separately 2d print the capacitative layer, then stick it on the bottom of the 3d printed piece: https://youtu.be/ON-6bdhQHpI https://youtu.be/ON-6bdhQHpI