4 ms·
airplanes too often were machined to fit. Where tollerances were used you got intrechangable parts and so could maintain it in the field - but that took a lot o
by bluGill 1y ago
airplanes too often were machined to fit. Where tollerances were used you got intrechangable parts and so could maintain it in the field - but that took a lot of skilled engineers.
- WalterBright 1y agoBoeing put in a lot of effort to specify the tolerances so they fit without needing rework. Engineers are only called in when the rework is not the same as the specification.
- bombcar 1y agoOne of the hardest parts of all this is that you can have a bunch of parts, all in tolerance, but since they’re all on the small side of the tolerance, they add up to something out of tolerance.
- bluGill 1y agoThat is something boeing but a lot of effort into, but many airplane makers didn't.
- WalterBright 1y agoSpecifying those tolerances was part of my job. It is not hard, it is simple arithmetic. Well, with some trig. I was amazed at the other engineers who would simply pick "good engineering tolerance" and never do the arithmetic. Once my lead engineer noticed that I sized the jackscrew length with a tolerance of 30.017 to 30.033 (I'm making up the numbers, as I don't recall the exact numbers). He said why not make it a nice round 30.02 to 30.03? I said that if the jackscrew came in at 30.018, it wouldn't need to be rejected and sent to rework. He thought for a moment, and said "carry on". LOL