4 ms·
If you have a hub generator system, they sell rear lights with controllers which detect changes in the frequency of the wheel rotation and start pulsing when yo
by smadge 1y ago
If you have a hub generator system, they sell rear lights with controllers which detect changes in the frequency of the wheel rotation and start pulsing when you decelerate.
- david-gpu 1y agoThat is so cool! Do you know of any brands/models?
- smadge 1y agoYeah, I have the Busch & Müller Toplight [1]. "The Toplight Line Brake Plus senses when the bike slows under braking and glows brighter. It does this by monitoring the AC frequency from the hub. During braking, the AC frequency slows quickly, and then makes the LEDs pulse or flicker, hopefully getting the attention of that fool in the jacked up SUV behind you." [1] https://www.rivbike.com/products/dyno-rack-light?srsltid=AfmBOorL3tQ4Eiv9FxUtylbyuqAZ2KQkzaX8s1tRbYEcG-Xh-R3SSJO- https://www.rivbike.com/products/dyno-rack-light?srsltid=Afm...
- mmooss 1y agoWhy not just connect them to the hand brake levers?
- smadge 1y agoThat would be more difficult, expensive, and unreliable. The light is powered by the rotation of the wheel so it already has a reliable braking signal.
- mmooss 1y agoHow is that difficult, expensive, or unreliable? What could be simpler than a switch that closes when a lever is closed, and turns on a light? That sounds much simpler, cheaper, and reliable than "detect changes in the frequency of the wheel rotation". Also, it works like a car's brake lights, which drivers are accustomed to, rather than "start pulsing when you decelerate", which is when you stop pedaling (unless going downhill).
- smadge 1y agoThe light is already by necessity hooked up to the wheel for power and adding a switch and wires to the brakes adds another point of failure making the system less reliable, makes installation more difficult because you have to wire up to the hub generator and the brakes, and more expensive because more components.